Dodge Durango (HB). Manual — part 1401
41. Install the upper (1) and lower (3) column shrouds
and install the screws.
42. Install the column tilt lever.
43. Install the steering column opening reinforcement
(1) and install the four screws.
44. Install the hood release handle (2) and install the
screws (5).
HB
INSTRUMENT PANEL
23 - 117
45. Install the steering column opening cover (2) and
install the two screws (1).
46. Install the left instrument panel end cap.
47. Instal the left cowl trim cover and install the
screw.
48. Install the left door sill trim cover and seat fully.
49. Do not reconnect the battery negative cable at
this time. The supplemental restraint system veri-
fication test procedure should be performed fol-
lowing
service
of
any
supplemental
restraint
system component. (Refer to 8 - ELECTRICAL/
RESTRAINTS
-
STANDARD
PROCEDURE
-
VERIFICATION TEST).
COVER-STEERING COLUMN OPENING
REMOVAL
1. Before proceeding with the following repair proce-
dure, review all warnings and cautions. (Refer to
23 - BODY/INSTRUMENT PANEL - WARNING)
2. Remove the two screws (1) and remove the open-
ing cover (2).
23 - 118
INSTRUMENT PANEL
HB
3. Remove the four screws (2) and remove the steer-
ing column opening reinforcement.
INSTALLATION
1. Before proceeding with the following repair proce-
dure, review all warnings and cautions. (Refer to
23 - BODY/INSTRUMENT PANEL - WARNING)
2. Install the opening reinforcement (1) and install the
four screws (2).
3. Install the opening cover (2) and seat fully.
4. Install the two screws (1).
HB
INSTRUMENT PANEL
23 - 119
BEZEL-CENTER
REMOVAL
1. Before proceeding with the following repair proce-
dure, review all warnings and cautions. (Refer to
23 - BODY/INSTRUMENT PANEL - WARNING)
2. Remove the two screws (2) and remove the bezel
(1).
3. Disconnect the electrical connectors and remove
the bezel.
23 - 120
INSTRUMENT PANEL
HB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст