Dodge Durango (HB). Manual — part 188
4. Install and tighten mounting fasteners.
5. Install instrument panel defroster grille (Refer to 23
-
BODY/INSTRUMENT
PANEL/DEFROSTER
GRILLE - INSTALLATION).
6. Install passenger airbag (Refer to 8 - ELECTRI-
CAL/RESTRAINTS/PASSENGER
AIRBAG
-
INSTALLATION).
7. Connect battery negative cable.
ANTENNA-SATELLITE
DESCRIPTION
The satellite radio antenna is secured by a threaded
fastener and two retainers which protrude through a
hole in the roof panel. Two wires from the antenna are
connected to the satellite receiver module located
above the headliner.
OPERATION
The satellite radio antenna receives signals from orbiting satellites and sends these signals to the satellite receiver
module. The satellite radio antenna must have open space in which to operate. Items carried on the roof, parking
inside etc. can have an effect on the antenna’s ability to receive signals.
HB
AUDIO/VIDEO - SERVICE INFORMATION
8A - 193
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Lower the rear portion of the headliner as neces-
sary to access underside of antenna (1) (Refer to
23 - BODY/INTERIOR/HEADLINER - REMOVAL).
3. Disconnect the wire harness connectors from the
antenna.
4. Remove fastener and retainer.
5. From inside the vehicle, and using a flat bladed
tool, depress one of the retaining tabs on the
antenna. Push up the one side of the antenna con-
nector through the roof panel. Depress the other
side of the connector and remove the antenna.
8A - 194
AUDIO/VIDEO - SERVICE INFORMATION
HB
INSTALLATION
1. Insert wire harness through hole in roof panel.
Press antenna into position until both retainers
snap into place.
2. Connect wire harness connectors to antenna.
3. Install and tighten retaining fastener.
4. Install headliner (Refer to 23 - BODY/INTERIOR/
HEADLINER - INSTALLATION).
5. Connect battery negative cable.
HB
AUDIO/VIDEO - SERVICE INFORMATION
8A - 195
ANTENNA CABLE-INSTRUMENT PANEL
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the right side cowl trim.
3. Reach under the instrument panel outboard of the
glove box to access and disconnect the antenna
coaxial cable connector (1) and (2). Disconnect the
connector by pulling it apart while twisting the
metal connector halves. Do not pull on the cable.
4. Disengage the instrument panel antenna cable
from the retainer clips on the glove box opening
and instrument panel support.
5. Remove the radio (1) (Refer to 8 - ELECTRICAL/
AUDIO/RADIO - REMOVAL).
CAUTION: Pulling the antenna cable straight out
of the radio without pulling on the locking antenna
connector could damage the cable or radio.
6. Disconnect the antenna cable by pulling the locking
antenna connector (2) away from the radio.
7. Pull the antenna cable out through the radio open-
ing in the instrument panel.
8A - 196
AUDIO/VIDEO - SERVICE INFORMATION
HB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст