Dodge Durango (HB). Manual — part 1100
INSTALLATION
1. Select the proper main bearings (Refer to 9 -
ENGINE/ENGINE
BLOCK/CRANKSHAFT
MAIN
BEARINGS - STANDARD PROCEDURE).
2. Install main bearings in block and caps, and lubri-
cate bearings.
3. Position the crankshaft into the cylinder block.
4. Install the thrust washers (1).
HB
ENGINE - 5.7L SERVICE INFORMATION
9 - 1399
NOTE: The main cap crossbolts are torqued after
final torque of the main cap bolts. Always use a
new washer/seal on crossbolts.
5. Clean and oil all cap bolts. Install all main bearing
caps (1). Install all cap bolts and alternately tighten
in two steps using the following sequence.
9 - 1400
ENGINE - 5.7L SERVICE INFORMATION
HB
6.
•
Step 1 – 27 N·m ( 20ft. lbs.) torque.
7.
•
Step 2 – Turn main cap bolts an additional 90°.
8. Install the crossbolts with new washer/gasket.
Starting with crossbolt A torque each crossbolt to
28 N·m ( 21ft. lbs.)torque.
9. Repeat crossbolt torque procedure.
10. Measure crankshaft end play (Refer to 9 -
ENGINE/ENGINE BLOCK/CRANKSHAFT MAIN
BEARINGS - STANDARD PROCEDURE).
11. Position the connecting rods onto the crankshaft and install the rod bearing caps (Refer to 9 - ENGINE/ENGINE
BLOCK/PISTON & CONNECTING ROD - INSTALLATION).
HB
ENGINE - 5.7L SERVICE INFORMATION
9 - 1401
12. Install timing drive (2) (Refer to 9 - ENGINE/
VALVE
TIMING/TIMING
BELT/CHAIN
AND
SPROCKETS - INSTALLATION).
13. Install oil pump (Refer to 9 - ENGINE/LUBRICATION/OIL PUMP - INSTALLATION).
9 - 1402
ENGINE - 5.7L SERVICE INFORMATION
HB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст