Dodge Ram Truck 1500-2500-3500. Manual — part 1973
REAR DOOR SEAL
1. Position the rear door seal to the bottom of the
door opening, with bulb facing outboard, starting
the installation at the center of the lower flange.
Press the seal onto the sill flange and work around
the perimeter of the door opening until fully seated.
Work in one direction, smoothing the seal to avoid
puckers or wrinkles.
2. Install the lower c-pillar trim (1) (Refer to 23 -
BODY/INTERIOR/C-PILLAR
TRIM
-
INSTALLATION).
23 - 246
WEATHERSTRIP/SEALS
DR/DH
3. Install the lower b-pillar trim (1) (Refer to 23 -
BODY/INTERIOR/B-PILLAR
LOWER
TRIM
-
INSTALLATION).
NOTE: When installing a new weatherstrip on the
rear door opening, remove the tear strip starting at
the splice and moving around the back of the door
to the front of the opening.
DRIP RAIL WEATHERSTRIP RETAINER
REMOVAL
1. Separate the drip rail weatherstrip (3) from the
weatherstrip retainer (1).
2. Remove the seven screws (2) and remove the
retainer (1).
DR/DH
WEATHERSTRIP/SEALS
23 - 247
INSTALLATION
1. Install the weatherstrip retainer (1) and install the
seven screws (2).
2. Position the weatherstrip (3) over the retainer
flange and seat fully.
FRONT DOOR GLASS RUN WEATHERSTRIP
REMOVAL
1. Remove the door glass (Refer to 23 - BODY/
DOOR - FRONT/DOOR GLASS - REMOVAL).
23 - 248
WEATHERSTRIP/SEALS
DR/DH
2. Separate the front door glass run weatherstrip (2)
out of the door frame (5) and remove through the
window opening.
INSTALLATION
NOTE: A mixture of soap and water may be used
to aid installation of the weatherstrip into the cor-
ners.
1. Position the front door glass run weatherstrip (2)
into the door (5) through the window opening.
2. Position the weatherstrip into the upper corners
and seat firmly.
3. From back to front, seat the weatherstrip between
the corners and then down the sides firmly.
DR/DH
WEATHERSTRIP/SEALS
23 - 249
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст