Dodge Ram Truck 1500-2500-3500. Manual — part 68
RULES
•
Good cancellation of U-joint operating angles should be within 1 degree.
•
Operating angles should be less than 3 degrees.
•
Operating angles less than 10 degrees for double cardan U-joint.
•
At least 1/2 of one degree continuous operating propeller shaft angle.
TWO PIECE PROPELLER SHAFT
Two piece propeller shaft angles measurement is the same as a one-piece propeller shaft.
3 - 104
PROPELLER SHAFT
DR/DH
STANDARD PROCEDURE - LUBRICATION
Vehicles with double cardan universal joint front pro-
peller shaft (1) are equipped with a grease fitting (2).
Grease the double cardan universal joint at each oil
change.
SPECIFICATIONS
PROPELLER SHAFT
TORQUE SPECIFICATIONS
DESCRIPTION
N·m
Ft. Lbs.
In. Lbs.
Center Bearing Bolts
54
40
-
Transfer Case Flange
Bolts
88
65
-
LD - Front Pinion Flange
Bolts
115
85
-
HD - Front Pinion Flange
Bolts
28
21
-
Rear Pinion Flange Bolts
115
85
-
Rear Pinion Yoke Bolts
29
22
-
DR/DH
PROPELLER SHAFT
3 - 105
SPECIAL TOOLS
3 - 106
PROPELLER SHAFT
DR/DH
SHAFT-PROPELLER LD FRONT
REMOVAL
1. With vehicle in neutral, position vehicle on hoist.
2. Remove exhaust crossover pipe.
3. Mark a line across the axle companion flange (1),
propeller shaft (2), flange yoke (3) and transfer
case for installation reference.
4. Remove axle/transfer case companion flange bolts.
Remove dust boot clamp (3) from the C/V jonit (1)
end of the shaft if equipped.
5. Remove propeller shaft.
DR/DH
PROPELLER SHAFT
3 - 107
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст