Dodge Ram Truck 1500-2500-3500. Manual — part 197
REAR TUBE / HOSE ASSEMBLY
1. Raise and support the vehicle.
2. Remove the brake line located at the axle.
3. Remove the mounting bolt (2) for the brake hose
(3) at the axle.
4. Remove the banjo bolt (1) at the caliper.
5. Remove the hose.
FRONT HOSE
1. Raise and support vehicle.
2. Remove the tire and wheel assembly.
3. Remove the brake hose (2) from the brake line
located at the frame.
4. Remove the brake hose banjo bolt (3) at the cali-
per.
5. Remove the mounting bolt securing the brake hose
(2) to the frame and remove the wheel speed sen-
sor wire (4) from the brake hose (2).
6. Remove the hose.
5 - 216
BRAKES - BASE - SERVICE INFORMATION
DR/DH
INSTALLATION
REAR BRAKE HOSE
1. Install the hose (1).
2. Install the mounting bolt for the brake hose (1) at
the axle.
3. Install the two brake lines (3) at the bottom of the
hose located at the axle.
4. Install the vent hose (2).
5. Install the brake hose clip (2) at the top of the hose
(1) located at the frame.
6. Install the brake line (3) to the hose at the frame.
7. Lower the vehicle and remove the support.
8. Bleed the brake system (Refer to 5 - BRAKES -
STANDARD PROCEDURE).
DR/DH
BRAKES - BASE - SERVICE INFORMATION
5 - 217
REAR TUBE / HOSE ASSEMBLY
1. Install the hose (3).
2. Install the banjo bolt (1) at the caliper and tighten
fitting bolt to 27 N·m (245 in. lbs.).
3. Install the mounting bolt (2) for the brake hose (3)
at the axle.
4. Install the brake line located at the axle.
5. Lower the vehicle and remove the support.
6. Bleed the brake system (Refer to 5 - BRAKES -
STANDARD PROCEDURE).
FRONT BRAKE HOSE
1. Install the hose (3).
2. Install the mounting bolt (1) for the brake hose (3)
at the frame.
3. Install the brake hose banjo bolt at the caliper.
4. Reinstall the wheel speed sensor wire (2) to the
brake hose.
5. Remove the support and lower the vehicle.
6. Bleed the brake system (Refer to 5 - BRAKES -
STANDARD PROCEDURE).
5 - 218
BRAKES - BASE - SERVICE INFORMATION
DR/DH
PADS - BRAKE
REMOVAL
FRONT
1. Raise and support vehicle.
2. Remove the wheel and tire assemblies.
3. Compress the caliper.
4. Remove the caliper (1), (Refer to 5 - BRAKES/HY-
DRAULIC/MECHANICAL/DISC BRAKE CALIPERS
- REMOVAL).
5. Remove the caliper (1) by tilting the top up and off
the caliper adapter (2).
NOTE: Do not allow brake hose to support caliper
assembly.
6. Support and hang the caliper (2).
DR/DH
BRAKES - BASE - SERVICE INFORMATION
5 - 219
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст