Dodge Ram Truck 1500-2500-3500. Manual — part 1888
7. Remove the front output shaft rear bearing with the
screw and jaws from Remover L-4454 (2) and Cup
8148 (3).
8. Install new bearing with Tool Handle C-4171 (1)
and Installer 5066 (3).
21 - 1484
TRANSFER CASE - NV244 GENII - SERVICE INFORMATION
DR/DH
9. Remove the rear output shaft bearing from the rear
case using Installer 5065 (2) and Handle C-4171
(1).
10. Install the rear output shaft bearing into the rear
case using Remover/Installer 6953 (2) and Handle
C-4171 (3).
DR/DH
TRANSFER CASE - NV244 GENII - SERVICE INFORMATION
21 - 1485
INPUT AND PLANETARY GEAR
1. Lubricate gears and thrust washers (5) with recom-
mended transmission fluid.
2. Install first thrust washer in low range gear (4). Be
sure washer tabs are properly aligned in gear
notches.
3. Install input gear (3) in low range gear (4). Be sure
input gear is fully seated.
4. Install remaining thrust washer (5) in low range
gear (4) and on top of input gear (3). Be sure
washer tabs are properly aligned in gear notches.
5. Install retainer (2) on input gear and install snap-
ring (1).
6. Align and install low range/input gear assembly (2)
in front case (1). Be sure low range gear pinions
are engaged in annulus gear and that input gear
shaft is fully seated in front bearing.
21 - 1486
TRANSFER CASE - NV244 GENII - SERVICE INFORMATION
DR/DH
7. Install snap-ring (2) to hold input/low range gear (1)
into front bearing.
8. Install a new input gear seal using Installer 8841
and Handle C-4171.
SHIFT FORKS AND MAINSHAFT
1. Lubricate mainshaft splines with recommended
transmission fluid.
NOTE: Replace the mode hub retainer if the legs
were distorted during removal.
2. Install the mode hub retainer (1) onto the mode
hub (2).
3. Install the mode hub (2) and mode hub retainer
onto the differential assembly (1). Make sure the
retainer is fully seated onto the differential.
DR/DH
TRANSFER CASE - NV244 GENII - SERVICE INFORMATION
21 - 1487
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст