Dodge Ram Truck 1500-2500-3500. Manual — part 91
INSTALLER 8881
SEAL INSTALLER 8882
ADJUSTER WRENCH 8883
SEAL INSTALLER 8885
INSTALLER 8886
PLUG 8888
3 - 196
FRONT AXLE - 9 1/4 AA
DR/DH
PINION DRIVER 8976
FLANGE WRENCH 8979
PINION INSTALLER 8982
FLANGE PULLER 8992
BRIDGE 938
DR/DH
FRONT AXLE - 9 1/4 AA
3 - 197
SHAFT-AXLE
REMOVAL
1. With the vehicle in neutral, position vehicle on
hoist.
2. Remove brake caliper, rotor and ABS wheel speed
sensor if equipped.
3. Remove axle shaft (2) cotter pin (3), hub nut (1)
and washer.
4. Remove four hub bearing bolts (2) from the back of
the steering knuckle.
5. Remove hub bearing from the steering knuckle.
3 - 198
FRONT AXLE - 9 1/4 AA
DR/DH
6. Remove axle shaft (2) from steering knuckle (1)
and axle housing.
DISASSEMBLY
Single cardan U-joint components are not serviceable.
If defective they must be replaced as a unit.
CAUTION: Clamp only the narrow forged portion
of the yoke in the vise. Failure to follow these
instructions will damage the yoke.
1. Remove the bearing cap (7) retaining snap rings
(8).
DR/DH
FRONT AXLE - 9 1/4 AA
3 - 199
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст