Dodge Ram Truck 1500-2500-3500. Manual — part 1565
32. Remove second gear bearing (1) from mainshaft
(2).
COUNTERSHAFT
NOTE: Bearings are the only component serviced on the countershaft.
1. Remove countershaft rear housing bearing with
Puller 6444 (1), Button 8513A (2), Puller Jaws
9597 (3) , Puller Collar 6444-8 (4), Puller Rods
6444-3 and Puller Flange 6444-1. Position Puller
Jaws 9597 around bearing and puller flange. Posi-
tion puller collar around the puller jaws. Tighten the
puller bolt and remove countershaft bearing.
2. Remove countershaft first/reverse gear bearing oil
slinger from countershaft.
21 - 192
MANUAL TRANSMISSION - G56 - SERVICE INFORMATION
DR/DH
3. Remove countershaft front housing bearing with
Puller 6444 (1), Puller Collar 6444-8 (2), Puller
Jaws 9597 (3), Puller Rods 6444-3 and Puller
Flange 6444-1. Position puller jaws around bearing
and puller flange. Position puller collar around the
puller jaws. Tighten the puller bolt and remove
countershaft bearing.
INPUT SHAFT
1. Remove input shaft (1) bearing with Puller C-293
(2) and Adapters C-293-47 (3).
2. Remove input shaft mainshaft bearing gasket.
DR/DH
MANUAL TRANSMISSION - G56 - SERVICE INFORMATION
21 - 193
3. Position input shaft (1) mainshaft bearing seal (2)
in a vice then twist input shaft (1) out of the seal
(2).
REAR HOUSING
1. Remove countershaft bearing cup and mainshaft
bearing cup with Puller 9593 (1) installed in cup
(2).
21 - 194
MANUAL TRANSMISSION - G56 - SERVICE INFORMATION
DR/DH
2. Install Remover 8915 (1) on puller (2) and tighten
remover nut (3) to pull cups out of the housing.
3. Remove output shaft seal (1) from housing (2) with
seal pick.
DR/DH
MANUAL TRANSMISSION - G56 - SERVICE INFORMATION
21 - 195
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст