Dodge Ram Truck 1500-2500-3500. Manual — part 1894
COMPANION FLANGE AND EXTENSION HOUSING
1. Install two bolts 180° apart into the front output
shaft companion flange.
2. Place holder (1) over the bolts (2) and against the
companion flange.
3. Remove and discard the front companion flange
nut.
4. Remove the companion flange from the front out-
put shaft. It may be necessary to use Flange puller
8992 to remove the companion flange.
5. Use a suitable chisel or pry tool to remove the rear
extension housing (1) dust boot (2).
6. Use a suitable chisel or pry tool to remove the rear
extension housing seal.
21 - 1508
TRANSFER CASE - NV273 - SERVICE INFORMATION
DR/DH
7. Remove rear extension (1) bolts (2).
8. Remove rear extension housing (2). Tap extension
once or twice with a plastic mallet to break sealer
bead and loosen it.
DR/DH
TRANSFER CASE - NV273 - SERVICE INFORMATION
21 - 1509
OIL PUMP AND REAR CASE
1. Disengage the oil pump pick-up tube (2) from the
oil pump (1).
NOTE: The oil pump pick-up tube seals to the oil
pump with an o-ring. Verify that the o-ring was
removed with the tube and is in good condition.
Replace the o-ring if necessary.
2. Remove the oil pump (3).
21 - 1510
TRANSFER CASE - NV273 - SERVICE INFORMATION
DR/DH
3. Remove rear case (2) -to-front case (1) bolts (3).
4. Remove the rear output shaft bearing inner snap-
ring (3) from the output shaft (1) using suitable
snap-ring pliers.
DR/DH
TRANSFER CASE - NV273 - SERVICE INFORMATION
21 - 1511
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст