Dodge Sprinter. Manual — part 414
TEST
ACTION
APPLICABILITY
3
Turn the ignition off.
Disconnect the Driver Cylinder Lock Switch connector.
Disconnect the Security System Module.
Measure the resistance between ground and the Driver Cylinder Lock Sense circuit.
Is the resistance below 400.0 ohms?
All
Yes
→ Repair the Driver Cylinder Lock Sense circuit for a short to
ground.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Replace the Security System Module.
Perform BODY VERIFICATION TEST - VER 1.
213
VEHICLE THEFT/SECURITY
DRIVER CYLINDER LOCK SWITCH CIRCUIT SHORT TO GROUND —
Continued
Symptom:
DRIVER CYLINDER UNLOCK SWITCH CIRCUIT SHORT TO
GROUND
When Monitored and Set Condition:
DRIVER CYLINDER UNLOCK SWITCH CIRCUIT SHORT TO GROUND
When Monitored:
Whenever the battery voltage is above 10.0 volts and the Security
System Module is connected.
Set Condition:
If the Driver Cylinder Unlock Circuit is closed to ground for over 30
seconds, this code will set.
POSSIBLE CAUSES
DTC PRESENT
DRIVER CYLINDER LOCK SWITCH SHORTED
DRIVER CYLINDER UNLOCK SENSE CIRCUIT SHORT TO GROUND
SECURITY SYSTEM MODULE SHORT TO GROUND
TEST
ACTION
APPLICABILITY
1
With the DRBIII
t, record and erase DTC’s.
Cycle the ignition switch from ON to OFF to ON.
With the DRBIII
t, read DTC’s.
Lock and unlock the doors from the Driver Cylinder Lock Switch several times while
observing the DRBIII
t.
Wait 10 seconds.
Does the DRBIII
t display DRIVER CYLINDER UNLOCK SWITCH CIRCUIT
SHORT TO GROUND?
All
Yes
→ Go To 2
No
→ The conditions that caused this code to set are not present at this
time. Using the wiring diagram/schematic as a guide, inspect the
wiring and connectors for an intermittent condition.
Perform BODY VERIFICATION TEST - VER 1.
2
Turn the ignition off.
Disconnect the Driver Cylinder Lock Switch connector.
Measure the resistance between ground and the Driver Cylinder Unlock Sense
circuit.
Is the resistance below 400.0 ohms?
All
No
→ Replace the Driver Cylinder Lock Switch.
Perform BODY VERIFICATION TEST - VER 1.
Yes
→ Go To 3
214
VEHICLE THEFT/SECURITY
TEST
ACTION
APPLICABILITY
3
Turn the ignition off.
Disconnect the Driver Cylinder Lock Switch connector.
Disconnect the Security System Module.
Measure the resistance between ground and the Driver Cylinder Unlock Sense
circuit.
Is the resistance below 400.0 ohms?
All
Yes
→ Repair the Driver Cylinder Unlock Sense circuit for a short to
ground.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Replace the Security System Module.
Perform BODY VERIFICATION TEST - VER 1.
215
VEHICLE THEFT/SECURITY
DRIVER CYLINDER UNLOCK SWITCH CIRCUIT SHORT TO GROUND —
Continued
Symptom:
FRONT DOOR JAMB SWITCH CIRCUIT SHORT TO GROUND
When Monitored and Set Condition:
FRONT DOOR JAMB SWITCH CIRCUIT SHORT TO GROUND
When Monitored:
Whenever the battery voltage is above 10.0 volts and the Security
System Module is connected.
Set Condition:
If a front door jamb switch is closed or the front courtesy lamps control
circuit is grounded for over 30 minutes, this code will set.
POSSIBLE CAUSES
DTC PRESENT
DRIVER DOOR JAMB SWITCH SHORTED
PASSENGER DOOR JAMB SWITCH SHORTED
SECURITY SYSTEM MODULE SHORTED
FRONT COURTESY LAMPS CONTROL SHORT TO GROUND
TEST
ACTION
APPLICABILITY
1
NOTE: Ensure the front courtesy lamp switches are operating properly
before proceeding.
NOTE: If this code is active, the front courtesy lamps will remain on with all
the doors closed.
With the DRBIII
t, record and erase DTC’s.
Cycle the ignition switch from ON to OFF to ON.
With the DRBIII
t, read DTC’s.
Open and close the front doors several times while observing the DRBIII
t.
Wait 10 seconds.
Does the DRBIII
t display FRONT DOOR JAMB SWITCH CIRCUIT SHORT TO
GROUND?
All
Yes
→ Go To 2
No
→ The conditions that caused this code to set are not present at this
time. Using the wiring diagram/schematic as a guide, inspect the
wiring and connectors for an intermittent condition.
Perform BODY VERIFICATION TEST - VER 1.
2
Turn the ignition off.
Disconnect the Driver Door Jamb Switch connector.
Ensure the passenger door is closed.
Observe the courtesy lamps.
Did the courtesy lamps go off?
All
Yes
→ Replace the Driver Door Jamb Switch.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Go To 3
216
VEHICLE THEFT/SECURITY
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст