Dodge Sprinter. Manual — part 10
Fig. 8 2 PIECE PROPELLER SHAFT
1 - FLANGE BOLT
6 - NUT
2 - BEARING
7 - BRACKET
3 - PROPELLER SHAFT
8 - RETAINING BRACKET
4 - REAR AXLE
9 - COLLARED BOLT
5 - CABLE BRACKET
10 - TRANSMISSION
3 - 8
PROPELLER SHAFT
VA
(6) Remove shaft from the vehicle.
INSTALLATION
(1) Install propeller shaft intermediate bearing/
bearings to support and tighten nuts to 105 N·m (77
ft. lbs.).
(2) Install propeller shaft intermediate bearing
support/supports to frame floor and tighten bolts to
95 N·m (70 ft. lbs.).
(3) Install propeller shaft intermediate bearing
with retaining bracket and bracket for brake cable.
NOTE: The bracket is only installed on vehicles
with wheelbase 3550 mm.
(4) Install propeller shaft to rear axle and trans-
mission flange with installation marks are aligned.
Tighten bolts to 70 N·m (66 ft. lbs.).
(5) Install retaining bracket and tighten bolts to
100 N·m (74 ft. lbs.).
CENTER BEARING
REMOVAL
(1) Remove propeller shaft.
(2) Mark shafts for installation alignment (Fig.
10).
(3) Loosen both collar clamps (Fig. 11).
Fig. 9 3 PIECE PROPELLER SHAFT
1 - FLANGE BOLT
7 - BRACKET
2 - INTERMEDIATE BEARING
8 - RETAINING BRACKET
3 - CENTER SHAFT
9 - BOLT
4 - REAR SHAFT
10 - FRONT SHAFT
5 - REAR AXLE
11 - TRANSMISSION
6 - NUT
Fig. 10 ALIGNMENT MARKS
1 - ALIGNMENT MARK
2 - BOOT
3 - ALIGNMENT MARK
4 - CENTER BEARING
VA
PROPELLER SHAFT
3 - 9
(4) Pull apart propeller shaft.
(5) Remove snap-ring (Fig. 12).
NOTE: If center bearing is equipped with a round
flange remove bolt from the middle of the flange.
(6) Pull off center bearing with a Bearing Splitter
1130 and Bridge 938, with a plug on the end of the
shaft (Fig. 13).
NOTE: The bearing splitter must be positioned
behind the thrust washer of the bearing.
INSTALLATION
(1) Press center bearing on propeller shaft with
protective caps and washer with Installer 9275 (Fig.
14).
Fig. 11 BOOT
1 - BOOT
2 - CLAMP
3 - SHAFT
Fig. 12 CENTER BEARING
1 - SNAP-RING
2 - CENTER BEARING
3 - WASHER
4 - SHAFT
5 - PROTECTIVE CAP
Fig. 13 CENTER BEARING REMOVAL
1 - BRIDGE
2 - PLUG
3 - BEARING SPLITTER
4 - CENTER BEARING
Fig. 14 CENTER BEARING INSTALLATION
1 - INSTALLER
2 - CENTER BEARING
3 - 10
PROPELLER SHAFT
VA
NOTE: If center bearing is equipped with a round
flange install new bolt in middle of the flange and
tighten to 95 N·m (70 ft. bls.).
(2) Install snap-ring.
(3) Coat propeller shaft spline with universal
grease.
(4) Push rubber boot onto propeller shaft.
(5) Push together propeller shaft. Pay attention to
alignment markings for installation position.
(6) Ensure rubber seal is correctly installed and
attach new collar clamps.
(7) Install propeller shaft.
VA
PROPELLER SHAFT
3 - 11
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст