Dodge Caliber. Manual — part 38
INSTALLATION
1. Lift driveline module (1) with a transmission jack
while installing halfshaft.
2. Install nut and washer halfshaft to left rear hub and
torque to 244 N·m (180 ft.lbs.).
3. Connect the electrical connector (1).
4. Install wire harness bracket and two mounting bolts
and torque to 45 Nm (33 ft. lbs.).
PM
HALF SHAFT-LEFT REAR
3 - 27
5. Lift driveline module into place.
6. Install the two driveline module side mounting bolts
(1) and torque to 102 N·m (75 ft. lbs.).
3 - 28
HALF SHAFT-LEFT REAR
PM
7. Install the rear driveline module mounting bolt (1)
and torque to 102 N·m (75 ft. lbs.).
8. Install the right side stay bracket and bolts (1)
torque to 61 N·m (45 ft. lbs.)
PM
HALF SHAFT-LEFT REAR
3 - 29
9. Install the left side stay bracket and bolts (1) torque
to 61 N·m (45 ft. lbs.).
10. Install the propeller shaft (Refer to 3 - DIFFERENTIAL & DRIVELINE/PROPELLER SHAFT - INSTALLATION).
11. Fill the rear axle with fluid.
12. Roll sway bar into place (2) (if equipped).
3 - 30
HALF SHAFT-LEFT REAR
PM
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст