Dodge Caliber. Manual — part 37
6. Remove left side sway bar nut (if equipped).
7. Roll sway bar down and out of the way (2) (if
equipped).
PM
HALF SHAFT-LEFT REAR
3 - 23
8. Remove the left side stay bracket bolts (1).
9. Remove the right side stay bracket bolts (1).
10. Remove the exhaust system up to the catalytic
converter. (Refer to 11 - EXHAUST SYSTEM/
MUFFLER - REMOVAL)
11. Support the rear driveline module with a transmis-
sion jack.
3 - 24
HALF SHAFT-LEFT REAR
PM
12. Remove the rear bolt (1) at the driveline module.
13. Remove the two side bolts (1) at driveline module
(3).
PM
HALF SHAFT-LEFT REAR
3 - 25
14. Lower drive line module enough gain access to
the electrical connector and bracket.
15. Remove the routing bracket bolt.
16. Unplug the electrical connector (1).
17. Lower the drive line module (1).
18. Disengage axle shaft.
19. Remove wheel if necessary.
20. Remove nut and washer halfshaft to left rear hub.
21. Remove halfshaft from rear hub, if hard to remove
or sticking, use a punch and hammer to tap out.
3 - 26
HALF SHAFT-LEFT REAR
PM
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст