Dodge Caliber. Manual — part 1128
16. Remove the lower control arm (3) front pivot bolts
(2).
17. Remove the lower control arm rear pivot bolts (3)
and separate the lower control arms from the
crossmember (1).
PM
FRAME & BUMPERS
13 - 23
INSTALLATION
1. Install the lower control arms and install the rear
pivot bolts (3).
2. Install the front pivot bolts (2).
13 - 24
FRAME & BUMPERS
PM
3. Support the crossmember on a suitable lifting device.
4. Raise the crossmember into position onto the vehicle.
5. Install the bolts (1 and 2) and align the engine cradle to the marks made during removal.
6. Tighten the bolts to 190 N·m (140 ft. lbs.).
7. Position the steering gear back into place and
install the bolts (1).
8. Tighten the bolts to 61 N·m (45 ft. lbs.).
PM
FRAME & BUMPERS
13 - 25
9. Position the stabilizer bar (2) back into place and
install the bushing bolts (1).
10. Tighten the bolts to 61 N·m (45 ft. lbs.).
11. Position the power steering lines back into place
and install the support bracket (2) bolts (1).
12. Tighten the bolts to 8 N·m (70 ft. lbs.).
13. Connect the lower ball joint stud (6) to the knuckle
(3).
14. Install a NEW ball joint stud pinch bolt (4) and nut
(5). Tighten the nut to 82 N·m (60 ft. lbs.).
13 - 26
FRAME & BUMPERS
PM
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст