Dodge Caliber. Manual — part 1127
CROSSMEMBER-FRONT SUSPENSION
REMOVAL
1. Raise and support the vehicle, (Refer to LUBRICA-
TION & MAINTENANCE/HOISTING - STANDARD
PROCEDURE).
2. Remove the four wheel well screws.
3. If equipped, remove the three front screws (4), the
three rear screws (2) and one push pin fastener
from the center of the belly pan.
4. Remove the rear roll mount (4) through bolt (2).
5. Remove the three bolts (3) attaching the rear roll
mount (5) to the crossmember and remove the
mount.
PM
FRAME & BUMPERS
13 - 19
6. Remove the for/aft crossmember (4) (Refer to 13 -
FRAME & BUMPERS/FRAME/CROSSMEMBER-
FRONT FORE/AFT - REMOVAL).
7. Remove the front wheels (1), (Refer to 22 - TIRES/
WHEELS
-
SERVICE
INFORMATION
-
REMOVAL).
8. Remove the lower ball joint (6) pinch bolts (4) and
nuts (5).
13 - 20
FRAME & BUMPERS
PM
9. Remove the bolt attaching the pressure line routing
bracket to the steering gear.
10. Remove the bolt attaching the return line to the
crossmember.
11. Remove the sway bar bushing bolts (1) and sup-
port the sway bar (2) up in the vehicle.
12. Remove the steering gear mounting bolts (1) and
support the steering gear (2) up in the vehicle.
PM
FRAME & BUMPERS
13 - 21
13. Mark the crossmember (3) to body location (1)
using a grease pencil (2) or equivalent.
14. Support the crossmember with a suitable lifting device.
15. Remove the crossmember bolts (1 and 2) and lower the crossmember from the vehicle.
13 - 22
FRAME & BUMPERS
PM
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст