Dodge Caliber. Manual — part 1174
HOSE-SUPPLY
REMOVAL
GAS ENGINE
NOTE: Before proceeding, (Refer to 19 - STEERING - WARNING).
1. Siphon as much fluid as possible from the power steering fluid reservoir.
2. Remove the clamp (2) securing the supply hose to
the power steering pump (3) supply fitting, then
remove the hose from the supply fitting.
3. Remove the hose clamp securing the supply hose
(4) to the power steering fluid reservoir (5). Slide
the hose off the end of the reservoir fitting and
remove from vehicle.
DIESEL ENGINE
NOTE: Before proceeding, (Refer to 19 - STEERING - WARNING).
1. Remove the engine top appearance cover.
2. Siphon as much fluid as possible from power steering fluid reservoir.
PM
PUMP
19 - 83
3. Remove the clamp securing the supply hose (3) to
the power steering pump supply fitting (2), then
remove the hose from the fitting (1).
4. Remove the hose clamp (4) securing supply hose
to the power steering fluid reservoir (5). Slide the
hose off the end of the reservoir fitting and remove
from vehicle.
19 - 84
PUMP
PM
INSTALLATION
GAS ENGINE
1. Slide hose clamps (2) onto both ends of the power
steering fluid supply hose (1) far enough to clear
the fittings on the reservoir and pump once the
hose is installed.
2. Place the pump end of the supply hose (1) onto
the pump (3) supply fitting. Expand the hose clamp
(2) and slide it over the hose and pump supply fit-
ting. Secure the clamp once it is past the bead
formed into the fluid supply fitting.
3. Expand the hose clamp (4) at the fluid reservoir (5)
and slide it over the hose and fitting. Secure the
clamp once it is past the bead formed into the fluid
reservoir fitting.
4. Perform the POWER STEERING PUMP BLEED
PROCEDURE. (Refer to 19 - STEERING - STAN-
DARD PROCEDURE)
5. Check for leaks at all hose connections.
PM
PUMP
19 - 85
DIESEL ENGINE
1. Slide hose clamps onto both ends of the power
steering fluid supply hose far enough to clear the
fittings on the reservoir and pump once hose is
installed.
2. Expand the hose clamp (4) at the fluid reservoir
end (5) and slide it over the hose and fitting.
Secure the clamp once it is past the bead formed
into the fluid reservoir fitting.
3. Place the pump end of the supply hose (1) onto
the pump supply fitting (2). Expand the hose clamp
and slide it over the hose and pump supply fitting.
Secure the clamp (3) once it is past the bead
formed into the fluid supply fitting.
4. Fill and bleed the power steering system. (Refer to
19 - STEERING - STANDARD PROCEDURE)
5. Check for leaks.
6. Install the engine appearance cover.
19 - 86
PUMP
PM
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст