Dodge Caliber. Manual — part 1335
4. Install four fasteners (1) fastening cluster to instru-
ment panel.
5. Install instrument panel upper panel. (Refer to 24 -
HEATING & AIR CONDITIONING/DISTRIBUTION/
FLOOR DISTRIBUTION DUCTS - REMOVAL)
PM
INSTRUMENT PANEL
23 - 77
BIN-GLOVE BOX
REMOVAL
1. Open glove box latch.
2. Unsnap glove box damper from glove box bin.
3. Flex glove box open position stops (1) inboard and
rotate past stops.
4. Unsnap glove box door from base panel lower
hinge pins (2).
INSTALLATION
1. Align glove box door with glove box opening.
2. Snap glove box door hinge pins (2) to lower base
panel hinges.
3. Flex glove box inboard and rotate inward past
stops (1).
4. Close glove box.
23 - 78
INSTRUMENT PANEL
PM
COVER-INSTRUMENT PANEL TOP
REMOVAL
1. Remove A- pillar trim. (Refer to 23 - BODY/INTE-
RIOR/A-PILLAR TRIM - REMOVAL)
2. Using trim stick C-4755, pry up on panel cover (1)
disengaging panel clip (2) from instrument panel
inner (3).
3. Remove from vehicle.
INSTALLATION
1. Place instrument panel cover (1) over instrument
panel aligning instrument panel cover clips over
instrument panel inner.
2. Tap on clip locations ensuring instrument panel
clips seat.
3. Install A - Pillar trim. (Refer to 23 - BODY/INTERI-
OR/A-PILLAR TRIM - INSTALLATION)
PM
INSTRUMENT PANEL
23 - 79
STEERING COLUMN COVER I/P
REMOVAL
1. Using trim stick C–4755, disengage clips on col-
umn cover top edge.
2. Remove from vehicle.
INSTALLATION
1. Align top of column cover tabs with instrument
panel.
2. Hand tap top of column cover ensuring column
cover tabs seat.
23 - 80
INSTRUMENT PANEL
PM
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст