Dodge Caliber. Manual — part 1334
24. Install manual or automatic shifter bezel. (Refer to 23 - BODY/INTERIOR/SHIFT BEZEL - INSTALLATION)
25. Connect steering column wire harness.
26. Connect steering column. (Refer to 19 - STEERING/COLUMN - INSTALLATION)
27. Install steering cover shrouds. (Refer to 23 - BODY/INSTRUMENT PANEL/IP STEERING COLUMN SUPPORT
BKT - INSTALLATION)
28. If equipped, install left and right airbag covers.
29. Install left and right end caps. (Refer to 23 - BODY/INSTRUMENT PANEL/INSTRUMENT PANEL END CAP -
INSTALLATION)
30. Connect the negative battery cable.
PM
INSTRUMENT PANEL
23 - 73
BEZEL-CENTER
REMOVAL
1. Remove shifter bezel.
2. Using trim stick C-4755, remove center bezel.
3. Disconnect wire harness from accessory switch
bank (2).
4. Disconnect HVAC control cables (1).
5. Remove fasteners attaching HVAC control head (3)
to bezel.
6. Remove switch bank (4) from bezel.
23 - 74
INSTRUMENT PANEL
PM
INSTALLATION
1. Install switch bank (4) onto bezel).
2. Route cables through center bezel and connect to
HVAC control head (3).
3. Connect control head (3) to center bezel.
4. Connect wire harness connectors to accessory
switch bank (2).
5. Hand tap center bezel on to instrument panel to
ensure proper seating.
PM
INSTRUMENT PANEL
23 - 75
BEZEL-CLUSTER
REMOVAL
1. Remove A - pillar trim.
2. Remove top cover. (Refer to 23 - BODY/INSTRUMENT PANEL/INSTRUMENT PANEL TOP COVER -
REMOVAL)
3. Remove fasteners and upper panel. (Refer to 23 - BODY/INSTRUMENT PANEL/INSTRUMENT PANEL TOP
COVER - REMOVAL)
4. Remove cluster bezel fasteners (1).
5. Pull instrument cluster rearward to expose the four
electrical connectors.
6. Disconnect electrical connectors.
7. Remove cluster assembly with cluster attached.
8. Remove fasteners (1) attaching cluster to bezel.
INSTALLATION
1. Install cluster to bezel by installing four fasteners
(1).
2. Position cluster into instrument panel opening.
3. Connect wire connectors.
23 - 76
INSTRUMENT PANEL
PM
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст