Dodge Caliber. Manual — part 1260
CAUTION: Set the spring compressor right on top
of the return spring of the spring retainer assem-
bly. Do not remove the return springs from the
spring retainer assembly.
72. Compress the reverse brake return spring using
Spring Compressor 5058A (1) and Reverse Piston
Compressor 9875. Remove the snap ring (2) from
the transaxle case.
73. Remove the retaining plate and the spring retainer
assembly.
CAUTION: There is a possibility that the reverse
brake piston might be stuck if excessive pressure
is required to remove.
74. Try removing the reverse brake piston from the
transaxle case by hand, apply compressed air to
the fluid passage (1). and remove the reverse
brake piston from the transaxle case if unable to
remove by hand.
PM
AUTOMATIC - CVT-SERVICE INFORMATION
21 - 339
75. Remove the case bolts (1) at the drive belt
assembly (2).
NOTE: Pin at pulley sensor stays with drive belt
assembly case
76. Separate drive belt assembly case from main
housing.
77. Remove the bolts (2) that hold both sheaves to
the case (1).
21 - 340
AUTOMATIC - CVT-SERVICE INFORMATION
PM
CAUTION: Do not allow the Sheave Compressor
9874 to come in contact with the belt at any time
78. Install the Sheave Compressor 9874 (1) and
Press Insert 8513A (2) onto the secondary sheave
(3).
CAUTION: Do not over tighten the compressor
tool. Tighten to no more than 7 N·m (50 in. lbs.)
NOTE: The belt is directional, look for an arrow
indicating the direction of the belt for installation
79. Compress sheave (2) to the stop.
PM
AUTOMATIC - CVT-SERVICE INFORMATION
21 - 341
CAUTION: Do not allow the primary sheave to con-
tact the drive surface of the secondary sheave.
NOTE: You may need to lightly tap case while
holding secondary sheave.
80. Lift and move the secondary sheave (1) closer to
the primary sheave.
81. Remove the pin (1) from the sheave height sen-
sor (3).
21 - 342
AUTOMATIC - CVT-SERVICE INFORMATION
PM
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст