Dodge Caliber. Manual — part 1258
52. Remove the sun gear (1) from the planetary
carrier.
53. Remove the needle bearing (1) from the sun gear.
PM
AUTOMATIC - CVT-SERVICE INFORMATION
21 - 331
54. Remove the planetary carrier assembly (1) from
the transaxle case.
55. Remove the needle bearing (1) from the planetary
carrier.
21 - 332
AUTOMATIC - CVT-SERVICE INFORMATION
PM
56. Remove the bolts holding the bracket (1) to the
valve body assembly.
57. Remove
the
bracket
from
the
valve
body
assembly.
58. Remove the nut holding the manual lever (1) to
the manual shaft.
59. Remove the manual lever.
PM
AUTOMATIC - CVT-SERVICE INFORMATION
21 - 333
60. Use this picture when removing valve body
attaching bolts.
CAUTION: Tilt the valve body assembly away from
the transaxle case on the manual shaft side to
ease removal. Pay attention to completely remove
the terminal body from the transaxle case.
61. Remove the valve body assembly from the trans-
axle case as follows:
a. Insert a 75 mm (3 in.) long 3 mm (0.118 in.)
rod or wire into the linkage stopper hole of the
valve body assembly to fix the pulley ratio link-
age (1).
b. Remove the bolts holding the valve body
assembly to the transaxle case.
c. Remove the valve body assembly from the
transaxle case.
21 - 334
AUTOMATIC - CVT-SERVICE INFORMATION
PM
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст