Dodge Caliber. Manual — part 157
4. Loosen, but do not remove, the two mounting
screws (2) attaching the ICU (1) mounting bracket
to the body.
5. Loosen the air inlet tube at the turbocharger.
6. Lower the vehicle.
7. Remove the engine appearance cover.
8. Loosen the air inlet tube at the air cleaner and
engine cylinder head cover, then remove the tube.
9. Loosen lower and upper mounting nuts, then
remove the heat shield from the dash panel.
10. Pull the brake tube bundle routing clips (with
tubes) loose from studs on the dash panel.
11. Remove primary (4) and secondary (1) brake
tubes (from master cylinder) at hydraulic control
unit (7).
12. Remove remaining brake tubes (2, 3, 5, 6) at
hydraulic control unit (7).
NOTE: Use this figure in the following step to
release the ABM harness connector cover. It
shows the location of the release tabs.
PM
BRAKES - ABS SERVICE INFORMATION
5 - 329
13. Disconnect the ABM harness connector from the
Antilock Brake Module (ABM). To do so:
a. Depress the tabs on each side of the connec-
tor cover, then
b. Pull outward and upward on the lower half of
the cover until it locks into position pointing
straight outward (2). The connector can then
be pulled straight outward off the ABM (1).
14. Lift the ICU and mounting bracket (1) off the
mounting screws (2).
15. Rotate the ICU (1) around behind the engine until
the bracket mounting screw (3) can be accessed.
16. Remove the ICU bracket mounting screw (3), then
remove the bracket (2) from the ICU (1). The ICU
has mounting pins that are inserted into grommets
in the bracket that must be overcome to remove
bracket.
5 - 330
BRAKES - ABS SERVICE INFORMATION
PM
17. Remove the ICU (1) from the engine compartment
out over the engine cylinder head cover (2).
18. To separate the ABM from the HCU, (Refer to 5 -
BRAKES/HYDRAULIC/MECHANICAL/ICU (INTE-
GRATED CONTROL UNIT) - DISASSEMBLY).
DISASSEMBLY
1. If the mounting bracket (3) needs to be removed
from the ICU, remove the single mounting bolt (2),
then slide the ICU’s mounting pins out of the grom-
mets in the bracket and remove the bracket.
PM
BRAKES - ABS SERVICE INFORMATION
5 - 331
2. Remove the mounting pins from the ICU.
3. If not equipped with traction control, remove the
three screws (1) attaching the ABM (2) to the HCU.
4. If equipped with traction control or ESP, remove the
four screws (1) attaching the ABM (2) to the HCU.
5 - 332
BRAKES - ABS SERVICE INFORMATION
PM
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст