Dodge Caliber. Manual — part 1366
NOTE: When properly adjusted, the rear edge of
the glass panel (3) is 1.0 mm (0.04 in.) to 2.0 mm
(0.08 in.) higher than the roof surface (2).
4. Verify sunroof operation and alignment. Check fit
and re-adjust as necessary.
PM
SUNROOF
23 - 201
HOSE-DRAIN
REMOVAL
1. Drop down the headliner as necessary to gain
access to the drain hoses (Refer to 23 - BODY/IN-
TERIOR/HEADLINER - REMOVAL).
2. Disconnect the front hoses (2) from the sunroof
assembly (1).
3. Release the support clips (3) and disconnect the
lower grommet and remove the hose.
4. Disconnect the rear hoses (2) from the sunroof
assembly (1) and release the support clips (3).
23 - 202
SUNROOF
PM
5. Separate the remaining support clips (1).
6. Disconnect the grommet (2) from the body (3) and
remove the rear hoses as necessary.
INSTALLATION
1. Install the rear hoses (4) and connect the grom-
mets (2) to the body (3).
2. Connect the support clips (1).
PM
SUNROOF
23 - 203
3. Route the hose as required and connect the
remaining support clips (3).
4. Connect the hoses (2) to the sunroof assembly (1).
5. Connect the front hose lower grommet to the body.
6. Connect the front hose (2) to the sunroof assembly
(1) and connect the support clips (3).
23 - 204
SUNROOF
PM
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст