Dodge Caliber. Manual — part 1287
2. Install small gear and shaft (3)onto large gear (4).
3. Using installer L-4507 (1) or a bearing heater install
the bearing (2) onto the shaft.
4. Using installer L-4507 (1) or a bearing heater install
the small gear side bearing onto the shaft.
PM
AUTOMATIC - CVT-SERVICE INFORMATION
21 - 447
5. Install the new reduction gear nut and torque to
250 N·m (184 ft. lbs.)
6. For two wheel vehicles use Installer C-3716 A and
Handle C-4171 or a bearing heater to install the
bearings onto the carrier (both sides). Use installer
9333-2 or a bearing heater on the big bearing and
Installer C-3716 A and Handle C-4171 on the small
bearing for four wheel drive vehicles.
21 - 448
AUTOMATIC - CVT-SERVICE INFORMATION
PM
7. Install the side gears (2) and shims (3) onto the
carrier.
8. Place the pinion gears (3) onto the side gears with
the correct shims (1).
9. Roll into place.
PM
AUTOMATIC - CVT-SERVICE INFORMATION
21 - 449
10. Install the pinion shaft (2).
11. Use a new roll pin (3).
21 - 450
AUTOMATIC - CVT-SERVICE INFORMATION
PM
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст