Dodge Caliber. Manual — part 1285
10. Install the new oil strainer (1) onto the control
valve assembly. Install and torque the mounting
bolts to 8 N·m (70 in. lbs.).
CAUTION: Do not re-use the oil pan gasket.
Remove any moisture, oil, and used gasket mate-
rial from the surface where the new gasket is to be
installed. When installing the oil pan gasket, align
the dowel pin with the dowel pin hole in the oil
pan gasket.
11. Install the oil pan gasket (1) onto the transaxle
case.
PM
AUTOMATIC - CVT-SERVICE INFORMATION
21 - 439
CAUTION: When installing the oil pan, align the
dowel pin of the transaxle case with the dowel pin
hole of the oil pan.
12. Install the oil pan on the transaxle case (1). Install
and torque the mounting bolts to 8 N·m (70 in.
lbs.).
13. Install the snap ring (1) onto the terminal body.
14. Fill transmission with the required fluid. (Refer to
21 - TRANSMISSION/TRANSAXLE/AUTOMATIC
- CVT/FLUID - STANDARD PROCEDURE)
21 - 440
AUTOMATIC - CVT-SERVICE INFORMATION
PM
DRIVE-FINAL
DISASSEMBLY
1. Remove the roll pin using a pin punch (1).
2. Discard the old roll pin (3).
PM
AUTOMATIC - CVT-SERVICE INFORMATION
21 - 441
3. Remove the pinion shaft (2) and inspect for exces-
sive ware.
4. Roll the pinion gears (3)and shims (1) out of the
carrier (2).
5. Remove the pinion gear shims (1) and mark for
installation.
21 - 442
AUTOMATIC - CVT-SERVICE INFORMATION
PM
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст