Dodge Caliber. Manual — part 1330
HOOD
TABLE OF CONTENTS
page
page
CABLE-LATCH RELEASE
HINGE
HOOD
REMOVAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 62
INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 62
LATCH
INSULATION - HOOD
PM
HOOD
23 - 57
CABLE-LATCH RELEASE
REMOVAL
1. Remove the wheel mounting nuts, then the front drivers side tire.
2. Remove front drivers side splash shield. (Refer to 23 - BODY/EXTERIOR/FRONT END SPLASH SHIELDS -
REMOVAL)
NOTE: See cable route.
3. Press down latch release (3) and remove cable (2)
from grommet (1).
4. Remove cable (2) from latch (3).
5. Follow cable and remove cable from push pin
grommets.
23 - 58
HOOD
PM
6. Remove fasteners (2) from hood release located
inside vehicle.
7. Remove cable from hood release (3).
INSTALLATION
1. Install fasteners (2).
2. Install cable into hood release lever (3), and route
cable (4) through grommet.
3. Remove splash shield. (Refer to 23 - BODY/EXTE-
RIOR/FRONT
END
SPLASH
SHIELDS
-
REMOVAL)
PM
HOOD
23 - 59
4. Route cable along underneath splash shield and
route toward radiator support.
5. Insert cable (2) into latch (3) and route front of
cable (1) into access hole.
23 - 60
HOOD
PM
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст