Dodge Caliber. Manual — part 351
4.
(L63) LEFT REAR TURN SIGNAL CONTROL CIRCUIT SHORTED TO VOLTAGE
Turn the ignition on.
Measure for voltage on the (L63) Left Rear Turn Signal Control circuit.
Is there any voltage present?
Yes
>> Repair short to voltage on the (L63) Left Rear Turn Signal
Control circuit
Perform the BODY VERIFICATION TEST - VER 1. (Refer to
8 - ELECTRICAL/ELECTRONIC CONTROL MODULES -
STANDARD PROCEDURE)
No
>> Replace the Totally Integrated Power Module (TIPM) in
accordance with the service information.
Perform the BODY VERIFICATION TEST - VER 1. (Refer to
8 - ELECTRICAL/ELECTRONIC CONTROL MODULES -
STANDARD PROCEDURE)
PM
LAMPS/LIGHTING - EXTERIOR - ELECTRICAL DIAGNOSTICS
8L - 37
B1647-REAR RIGHT TURN CONTROL CIRCUIT LOW
For a complete wiring diagram Refer to Section 8W.
8L - 38
LAMPS/LIGHTING - EXTERIOR - ELECTRICAL DIAGNOSTICS
PM
•
When Monitored:
•
With the Turn Signal activated.
•
Set Condition:
•
When the TIPM detects a LOW condition.
Possible Causes
(L62) REAR RIGHT TURN SIGNAL CONTROL CIRCUIT
TOTALLY INTEGRATED POWER MODULE
Diagnostic Test
1.
INTERMITTENT CONDITION
Turn the ignition on.
With the Scan Tool, clear all TIPM DTC’s.
Turn the Right Turn Signals on.
With the Scan Tool read the DTC information.
Does the Scan Tool read: B1647-REAR RIGHT TURN CONTROL CIRCUIT LOW?
Yes
>> Go To 2
No
>> The condition that caused the symptom is currently not present. Inspect the related wiring for a possible
intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires.
Perform the BODY VERIFICATION TEST-VER1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES - STANDARD PROCEDURE)
2.
(L62) RIGHT REAR TURN SIGNAL CONTROL CIRCUIT
Turn the ignition off.
Disconnect theTIPM C3 connector.
Disconnect the Right Rear Tail Lamp harness connector.
Measure the resistance between ground and the (L62) Right Rear Turn
Signal Control circuit.
Is the resistance below 5.0 ohms?
Yes
>> Repair the (L62) Right Rear Turn Signal Control circuit for a
short to ground.
Perform the BODY VERIFICATION TEST-VER1. (Refer to 8
-
ELECTRICAL/ELECTRONIC
CONTROL MODULES
-
STANDARD PROCEDURE)
No
>> Replace the Totally Integrated Power Module (TIPM) in
accordance with the service information.
Perform the BODY VERIFICATION TEST-VER1. (Refer to 8
-
ELECTRICAL/ELECTRONIC
CONTROL MODULES
-
STANDARD PROCEDURE)
PM
LAMPS/LIGHTING - EXTERIOR - ELECTRICAL DIAGNOSTICS
8L - 39
B1648-REAR RIGHT TURN CONTROL CIRCUIT HIGH
For a complete wiring diagram Refer to Section 8W.
8L - 40
LAMPS/LIGHTING - EXTERIOR - ELECTRICAL DIAGNOSTICS
PM
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст