Dodge Caliber. Manual — part 1352
4. Install the lower seat belt anchor (1) and install the
bolt (2).
5. Tighten the bolt (2) to 39 N·m (29 ft. lbs.) and
install the trim cover (3).
6. Do not reconnect the battery negative cable at this
time. The occupant classification module system
verification test procedure should be performed fol-
lowing service of any supplemental restraint system
component.
(Refer
to
8
-
ELECTRICAL/RE-
STRAINTS - DIAGNOSIS AND TESTING - *OCCU-
PANT
CLASSIFICATION
MODULE
SYSTEM
VERIFICATION TEST)
PM
SEATS
23 - 145
SEAT BACK - FRONT
REMOVAL
Driver Seat
1. Before proceeding with the following repair proce-
dure, review all warnings and cautions. (Refer to
23 - BODY/SEATS - WARNING)
2. Remove the seat cushion (Refer to 23 - BODY/
SEATS/SEAT CUSHION - FRONT - REMOVAL).
3. Remove both of the inner side shields (2).
4. Remove the lift lever trim cap (2).
5. Remove the screws (2) and remove the lift lever
(1).
23 - 146
SEATS
PM
6. Separate the clip (2).
7. Remove the recliner handle (1).
8. Remove the screws (2) attaching the inboard and
outboard side shields (1) to the seat frame.
PM
SEATS
23 - 147
9. Separate the clip fasteners (2) and remove the side
shields from the seat cushion frame tabs (1).
10. Remove the bolts (1) and remove the seat back
assembly (2).
Passenger Seat
1. Before proceeding with the following repair proce-
dure, review all warnings and cautions. (Refer to
23 - BODY/SEATS - WARNING)
2. Remove the seat cushion (Refer to 23 - BODY/
SEATS/SEAT CUSHION - FRONT - REMOVAL).
3. Fold the seat back (1) into the down position.
23 - 148
SEATS
PM
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст