Dodge Caliber. Manual — part 1268
66. Install the bracket (1) onto the valve body assem-
bly. Install and Torque the mounting bolts to 8 N·m
(70 in.lbs.).
CAUTION: Do not re-use the o-ring. Apply CVT
fluid when installing the o-ring.
67. Install the new o-ring (1) onto the new oil strainer.
PM
AUTOMATIC - CVT-SERVICE INFORMATION
21 - 371
68. Install the new oil strainer (1) onto the valve body
assembly. Install and Torque the mounting bolts to
8 N·m (70 in.lbs.).
CAUTION: Do not re-use the oil pan gasket.
Remove any moisture, oil, and used gasket mate-
rial from the surface where the new gasket is to be
installed. When installing the oil pan gasket, align
the dowel pin with the dowel pin hole in the oil
pan gasket.
69. Install the oil pan gasket (1) onto the transaxle
case.
21 - 372
AUTOMATIC - CVT-SERVICE INFORMATION
PM
CAUTION: When installing the oil pan, align the
dowel pin of the transaxle case with the dowel pin
hole of the oil pan.
70. Install the oil pan on the transaxle case (1). Install
and Torque the mounting bolts to 8 N·m (70
in.lbs.).
71. Install the snap ring (1) onto the terminal body.
PM
AUTOMATIC - CVT-SERVICE INFORMATION
21 - 373
CAUTION: Do not re-use the seal rings. Apply
Vaseline or assembly lube when installing the seal
rings.
72. Install the new seal rings (1) onto the reaction
shaft support.
73. Install the reaction shaft support (1) onto the
transaxle case temporarily with the mounting
bolts.
21 - 374
AUTOMATIC - CVT-SERVICE INFORMATION
PM
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст