Dodge Caliber. Manual — part 1200
![](/vehicles/wlang/mes/adolos/vena.png)
BUSHINGS-SHIFT RAIL
REMOVAL
1. Thread Remover 6786 (1) into shift rail bushing.
2. Install slide hammer C-3752 (2) onto tool.
3. Remove bushing (3) using slide hammer and tool
assembly.
INSTALLATION
1. Line up replacement bushing in bore.
2. Using Installer MD998343, tap bushing into bore until flush with the chamfer in the case.
PM
T355 MANUAL TRANSAXLE
21 - 99
SHAFT-SHIFT SELECTOR
REMOVAL
1. Disassemble transaxle.
2. With the transaxle disassembled, remove the selector shaft by pushing on the shaft from the outside. Pull shaft
out from the inside.
INSTALLATION
1. Pull selector shaft into position from the outside.
2. Assemble transaxle.
21 - 100
T355 MANUAL TRANSAXLE
PM
![](/vehicles/wlang/mes/adolos/dofis.png)
BUSHING-SHIFT SELECTOR SHAFT
REMOVAL
1. Remove selector shaft using procedure in this
group.
2. Thread Remover 6786 (1) into bushing.
3. Install slide hammer C-3752 (3) onto tool and
remove bushing (2) using slide hammer
.
INSTALLATION
1. Position replacement bushing over selector shaft
bore.
2. Using an appropriate size deep-well socket (1),
install bushing (2) in selector shaft bore.
PM
T355 MANUAL TRANSAXLE
21 - 101
SEALS-SHIFT SHAFT
REMOVAL
It is not necessary to remove the shift shafts from the transaxle to service the shift shaft seals.
1. Using a pick tool, pry up on the shift shaft seal, and remove seal from bore.
INSTALLATION
1. Position new shift shaft seal into bore.
2. Install shift shaft seal into bore using an appropriate size deep-well socket.
21 - 102
T355 MANUAL TRANSAXLE
PM
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст