Dodge Neon / Neon SRT-4. Manual — part 495
Symptom:
*AUTOMATIC DOOR LOCKS INOPERATIVE
POSSIBLE CAUSES
AUTO DOOR LOCKS NOT ENABLED
DOOR AJAR STATUS
PCM DTC’S PRESENT
RKE MODULE DEFECTIVE - AUTO LOCKS INOPERABLE
TEST
ACTION
APPLICABILITY
1
With the DRBIII select:
9Theft Alarm9 9VTSS9 9Miscellaneous9 9Auto Door Locks9
Does the DRB show
9Auto Door Locks: ENABLED9?
All
Yes
→ Go To 2
No
→ With the DRBIII, enable the Auto Door Locks and retest the
System.
Perform BODY VERIFICATION TEST - VER 1.
2
Ensure all doors are closed.
With the DRBIII read all DOOR AJAR states
Do any door ajar states show CLOSED?
All
Yes
→ Refer to symptom COURTESY LAMPS ON AT ALL TIMES in the
INTERIOR LIGHTING category.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Go To 3
3
With the DRBIII read
9Engine9 DTC’s.
Are there any TPS or Vehicle Speed DTC’s present?
All
Yes
→ Refer to symptom list for problems related to DRIVEABILITY..
Perform BODY VERIFICATION TEST - VER 1.
No
→ Go To 4
4
If there are no possible causes remaining, view repair.
All
Repair
Replace the Remote Keyless Entry Module.
Perform BODY VERIFICATION TEST - VER 1.
202
POWER DOOR LOCKS/RKE
Symptom:
*DECKLID SOLENOID INOPERATIVE
POSSIBLE CAUSES
SOLENOID GROUND OPEN
DECKLID RELEASE SOLENOID OPEN
DECKLID RELEASE RELAY OUTPUT WIRE OPEN
RKE MODULE - DECKLID RELAY OPEN
TEST
ACTION
APPLICABILITY
1
Disconnect the Decklid Solenoid connector.
Connect a test light between the Decklid Release Relay Output circuit and the
Ground circuit in the Decklid Solenoid connector.
With the DRBIII actuate the
9Decklid Solenoid9.
Did the test light illuminate when the solenoid was actuated?
All
Yes
→ Replace the Decklid Release Solenoid.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Go To 2
2
Turn ignition off.
Disconnect the Decklid Solenoid connector.
Using a 12-volt test light connected to 12-volts, check the Ground circuit in the
Decklid Release connector.
Does the test light illuminate brightly?
All
Yes
→ Go To 3
No
→ Repair the open ground wire.
Perform BODY VERIFICATION TEST - VER 1.
3
Turn ignition off.
Disconnect the Remote Keyless Entry module connector.
Disconnect the Decklid Solenoid connector.
Measure the resistance of the Decklid Release Relay Output wire from the RKE
module connector to the Decklid Solenoid connector.
Is the resistance below 5.0 ohms?
All
Yes
→ Go To 4
No
→ Repair the open Decklid Release Relay Output wire.
Perform BODY VERIFICATION TEST - VER 1.
4
If there are no possible causes remaining, view repair.
All
Repair
Replace the Remote Keyless Entry Module.
Perform BODY VERIFICATION TEST - VER 1.
203
POWER DOOR LOCKS/RKE
Symptom:
*DOORS LOCKABLE WITH KEY IN IGNITION & DRIVER DOOR
OPEN
POSSIBLE CAUSES
DRIVER DOOR AJAR SWITCH - OPEN
OPEN DRIVER DOOR AJAR SWITCH SENSE TO RKE MODULE
IGNITION SWITCH OPEN
KEY-IN IGNITION SWITCH SENSE WIRE OPEN
OPEN DRIVER DOOR AJAR SWITCH SENSE TO CLUSTER
INSTRUMENT CLUSTER - KEY-IN IGNITION OPEN
INSTRUMENT CLUSTER DEFECTIVE-DRIVER DOOR AJAR OPEN
RKE MODULE DEFECTIVE-OPEN DRIVER DOOR AJAR
TEST
ACTION
APPLICABILITY
1
Open the Drivers door.
With the DRB III select:
9Body9 9Electro/Mech Cluster9 9Input/Output9
Read the
9Drv Door Ajar Sw9 state.
Does the DRBIII Show:
9CLOSED9?
All
No
→ Go To 2
Yes
→ Go To 5
2
Remove the driver door inner trim panel to gain access to the Door Lock Motor/Ajar
Switch connector.
Disconnect the Door Lock Motor/ Ajar Switch connector (Left Front or Right Front).
Connect a jumper wire between Door Ajar Switch Sense circuit (driver door) and
ground.
With the DRB III select:
9Body9 9Electro/Mech Cluster9 9Input/Output9
Read the
9Drv Door Ajar Sw9 state.
Does the DRBIII show:
9Closed9?
All
Yes
→ Replace the Driver Door Ajar Switch.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Go To 3
3
Turn ignition off.
Disconnect the Door Lock Motor/Ajar Switch (driver door) connector.
Disconnect the Instrument Cluster connector.
Measure the resistance of the Door Ajar Switch Sense (driver door) circuit between
the Door Lock Motor/Ajar Switch connector and the Instrument Cluster connector.
Is the resistance below 5.0 ohms?
All
Yes
→ Go To 4
No
→ Repair the Driver Door Ajar Switch Sense wire for an open.
Perform BODY VERIFICATION TEST - VER 1.
204
POWER DOOR LOCKS/RKE
TEST
ACTION
APPLICABILITY
4
If there are no possible causes remaining, view repair.
All
Repair
Replace the Instrument Cluster
Perform BODY VERIFICATION TEST - VER 1.
5
Note: Ensure that the Key is still in the Ignition Switch.
With the DRB, read the Key-In Ignition status.
Does the DRB show KEY-IN IGN: CLOSED ?
All
No
→ Go To 6
Yes
→ Go To 9
6
Ensure the Instrument Cluster is connected before proceeding.
Disconnect the Ignition Switch connector.
Connect a jumper wire from the Key-In Ignition Switch Sense circuit in the ignition
switch connector to ground.
With the DRB, read the Key-In Ignition status.
Does the DRB show KEY-IN IGN: CLOSED ?
All
Yes
→ Replace the Ignition Switch.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Go To 7
7
Disconnect the Ignition Switch connector.
Disconnect the Instrument Cluster connector.
Measure the resistance of the Key-In Ignition Switch Sense circuit between the
ignition switch connector and the instrument cluster connector.
Is the resistance below 5.0 ohms?
All
Yes
→ Go To 8
No
→ Repair the open Key-In Ignition Switch Sense wire.
Perform BODY VERIFICATION TEST - VER 1.
8
If there are no possible causes remaining, view repair.
All
Repair
Replace the Instrument Cluster (key-in ign open).
Perform BODY VERIFICATION TEST - VER 1.
9
Turn ignition off.
Remove the driver door inner trim panel.
Disconnect the Driver Door Lock Motor/Ajar Switch connector.
Disconnect the RKE Module connector.
Measure the resistance of the Driver Door Ajar Switch Sense circuit between the
Driver Door Lock Motor/Ajar Switch connector and the RKE module connector.
Is the resistance below 5.0 ohms?
All
Yes
→ Go To 10
No
→ Repair the open Driver Door Ajar Switch Sense wire.
Perform BODY VERIFICATION TEST - VER 1.
10
If there are no possible causes remaining, view repair.
All
Repair
Replace the Remote Keyless Entry Module.
Perform BODY VERIFICATION TEST - VER 1.
205
POWER DOOR LOCKS/RKE
*DOORS LOCKABLE WITH KEY IN IGNITION & DRIVER DOOR OPEN —
Continued
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст