Dodge Nitro. Manual — part 437
Fig. 389: Instrument Panel, Slots & Moldings
Courtesy of CHRYSLER LLC
1. Using a small pry tool or equivalent, lift the A-pillar trim molding (3) from the A-pillar slots (2) releasing
the clips on the molding.
2. Remove the top clip from the trim molding.
INSTALLATION
MOLDING - A PILLAR
Fig. 390: Instrument Panel, Slots & Moldings
Courtesy of CHRYSLER LLC
1. Align the A-pillar trim tab on the molding (3) to the top cover slot of the instrument panel (1).
2. Install the top clip on the trim molding.
3. Align the two clips on the molding to the slots (2) on the A-pillar. Snap the A-pillar trim molding (3) into
place using hand pressure.
MOLDING - HEADLINER
REMOVAL
MOLDING - HEADLINER
NOTE:
The top tethered clip has a locking tab that needs to be lifted in order for
clip to slide out of the trim attachment point.
2007 Dodge Nitro R/T
2007 ACCESSORIES AND EQUIPMENT Body - Nitro
Fig. 391: Headliner Molding
Courtesy of CHRYSLER LLC
1. Open the lift gate.
2. Pull down at the center of the headliner molding (3) only enough to allow the tab (2) to be released from
the quarter trim molding.
3. Carefully pull down to remove the remaining clips (4) attaching the molding to the body then move the
molding to the left to released the tab from the quarter trim molding.
INSTALLATION
MOLDING - HEADLINER
Fig. 392: Headliner Molding
NOTE:
Align second clip from Right (Cross Car Locator) to its slot first. This
helps line up the rest of clips.
2007 Dodge Nitro R/T
2007 ACCESSORIES AND EQUIPMENT Body - Nitro
Courtesy of CHRYSLER LLC
1. Install the headliner molding (3) to the body by sliding the tab (1) on the right side into the quarter trim
molding.
2. Pull down at the center of the headliner molding (3) only enough to allow the tab (2) to be slide into the
other side of the quarter trim molding.
3. Using hand pressure snap the remaining clips (4) into place.
4. Close the lift gate.
PANEL - COWL SIDE
REMOVAL
PANEL - COWL SIDE
Fig. 393: Cowl Trim Panel
Courtesy of CHRYSLER LLC
1. Using a trim stick C-4755 or equivalent, remove the cowl trim cover (1) by pulling it away from the A-
pillar and releasing the clip (2), continue lifting up the cowl trim panel (1) to release the clips (3) from the
body.
INSTALLATION
PANEL - COWL SIDE
2007 Dodge Nitro R/T
2007 ACCESSORIES AND EQUIPMENT Body - Nitro
Fig. 394: Cowl Trim Panel
Courtesy of CHRYSLER LLC
1. Align and install the cowl trim cover (1) by sliding the rear tabs of the cowl trim cover under the B-pillar
trim.
2. Using hand pressure install the clips (3) into the body and the A-pillar (2).
PANEL - LOAD FLOOR
REMOVAL
PANEL - LOAD FLOOR
CAUTION: When installing the cowl trim cover make sure not to damage the
body plugs around the sill area. If damage occurs to the body plugs
replace with new plugs. Failure to replace a damaged body plug will
result in a water leak to the floor area of the vehicle.
2007 Dodge Nitro R/T
2007 ACCESSORIES AND EQUIPMENT Body - Nitro
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст