Dodge Nitro. Manual — part 438
Fig. 395: Load Floor Panel, Load Floor & Rear Seat Bracket
Courtesy of CHRYSLER LLC
1. Position the rear seats in the forward position.
2. Remove the load floor panel (1) from the load floor (2) and the rear seat bracket (3).
INSTALLATION
PANEL - LOAD FLOOR
Fig. 396: Load Floor Panel, Load Floor & Rear Seat Bracket
Courtesy of CHRYSLER LLC
1. Install the load floor panel (1) to the load floor (2) and the rear seat bracket (3). Use hand pressure to seat
the clips.
2. Return the rear seats in the upright position.
PANEL - QUARTER TRIM
2007 Dodge Nitro R/T
2007 ACCESSORIES AND EQUIPMENT Body - Nitro
REMOVAL
PANEL - QUARTER TRIM
Fig. 397: Quarter Trim Panel
Courtesy of CHRYSLER LLC
1. Using a trim stick C-4755 or equivalent, remove the rear door scuff plate, see REMOVAL.
2. Fold down the rear seat.
3. Remove the C-pillar cover, see REMOVAL.
4. Remove the screws and the cargo tie downs.
5. Remove the quarter trim panel (1) by carefully pulling at the clip locations (3).
Fig. 398: Quarter Trim Panel Electrical Connector
Courtesy of CHRYSLER LLC
6. If replacing the left side quarter trim panel disconnect the 12v power supply electrical connector (2) from
2007 Dodge Nitro R/T
2007 ACCESSORIES AND EQUIPMENT Body - Nitro
the socket (1).
INSTALLATION
PANEL - QUARTER TRIM
Fig. 399: Quarter Trim Panel Electrical Connector
Courtesy of CHRYSLER LLC
1. If installing the left side quarter trim panel connect the 12v power supply electrical connector (2) from the
socket (1).
Fig. 400: Quarter Trim Panel
Courtesy of CHRYSLER LLC
2. Install the quarter trim panel (1) to the inside of the vehicle, carefully align and install the bottom of the
quarter trim panel slots into the load floor first. Then continue to seat the remaining clips on the panel,
working from the bottom up. Use hand pressure to seat the clips (3).
2007 Dodge Nitro R/T
2007 ACCESSORIES AND EQUIPMENT Body - Nitro
3. Install the cargo tie downs and tighten the screw.
4. Install the rear door scuff plate, see INSTALLATION.
5. Install the C-pillar cover, see INSTALLATION.
6. Return the rear seat to the up position.
PLATE - SCUFF
REMOVAL
PLATE - SCUFF
Fig. 401: Rear Door Scuff Plate
Courtesy of CHRYSLER LLC
1. Open the lift gate.
2. Using a trim stick C-4755 or equivalent, release the retaining clips and remove the scuff plate (1) from
the body (2).
INSTALLATION
PLATE - SCUFF
2007 Dodge Nitro R/T
2007 ACCESSORIES AND EQUIPMENT Body - Nitro
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст