Dodge Nitro. Manual — part 151
Disconnect the Brake Fluid Level Switch harness connector.
Reconnect the TIPM harness connector.
Measure the resistance of the (Z905) Brake Fluid Level Switch ground circuit between the Brake Fluid
Level Switch harness connector and ground.
Is the resistance below 5.0 ohms?
Yes
Replace and program the Totally Integrated Power Module in accordance with the Service
Information.
Perform ABS VERIFICATION TEST.
No
Repair the open or high resistance in the (Z905) Sensor ground circuit.
Perform POWERTRAIN VERIFICATION TEST .
C100A-LEFT FRONT WHEEL SPEED SENSOR CIRCUIT
2007 Dodge Nitro R/T
2007 BRAKES ABS - Electrical Diagnostics - Nitro
Fig. 5: Wheel Speed Sensor Circuit Schematic
Courtesy of CHRYSLER LLC
For complete wiring diagrams refer to SYSTEM WIRING DIAGRAMS article.
When Monitored:
2007 Dodge Nitro R/T
2007 BRAKES ABS - Electrical Diagnostics - Nitro
With the ignition on.
Set Condition:
When the Left Front Wheel Speed Sensor (WSS) circuit fails the diagnostic test.
Diagnostic Test
1) CHECK FOR DTC C100A-LEFT FRONT WHEEL SPEED SENSOR CIRCUIT
Turn the ignition on.
With the scan tool, record and erase DTCs.
Cycle the ignition switch from off to on.
With the scan tool, read DTCs.
Does the scan tool display: C100A-LEFT FRONT WHEEL SPEED SENSOR CIRCUIT?
Yes
Go to 2).
No
The condition that caused the symptom is currently not present. Inspect the related wiring for a
possible intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires.
Refer to the ABS INTERMITTENT CONDITION.
2) CHECK CONNECTOR/TERMINAL FOR DAMAGE
Possible Causes
WIRING HARNESS, TERMINAL, CONNECTOR DAMAGE
(B9) LEFT FRONT WSS 12 VOLT SUPPLY CIRCUIT SHORTED TO VOLTAGE, GROUND, OR
OPEN
(B8) LEFT FRONT WSS SIGNAL CIRCUIT SHORTED TO VOLTAGE, GROUND, OR OPEN
(B8) LEFT FRONT WSS SIGNAL CIRCUIT SHORTED TO (B9) LEFT FRONT WSS 12 VOLT
SUPPLY CIRCUIT
LEFT FRONT WSS
ANTI-LOCK BRAKES MODULE
NOTE:
This DTC must be active for the results of this test to be valid.
NOTE:
Check all terminals for broken, bent, pushed out, or corroded terminals.
2007 Dodge Nitro R/T
2007 BRAKES ABS - Electrical Diagnostics - Nitro
Turn the ignition off.
Inspect the Anti-Lock Brake Module harness connector, Left Front WSS, and Left Front WSS harness
connector.
Is the Left Front WSS or any of the connectors/terminals damaged?
Yes
Repair as necessary.
Perform ABS VERIFICATION TEST.
No
Go to 3).
3) CHECK (B9) LEFT FRONT WSS 12 VOLT SUPPLY CIRCUIT VOLTAGE
2007 Dodge Nitro R/T
2007 BRAKES ABS - Electrical Diagnostics - Nitro
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст