Dodge Nitro. Manual — part 150
Fig. 2: Brake Fluid Level Switch
Courtesy of CHRYSLER LLC
Turn the ignition off.
2007 Dodge Nitro R/T
2007 BRAKES ABS - Electrical Diagnostics - Nitro
Connect a jumper wire between the (B20) Brake Fluid Level signal circuit and the (Z905) Brake Fluid
Level ground circuit in the Brake Fluid Level Switch harness connector
Turn the ignition on.
With the scan tool, read the Brake Fluid Level Switch voltage
Is the voltage below 1.0 volt?
Yes
Replace the Brake Fluid Level Switch in accordance with the Service Information.
Perform ABS VERIFICATION TEST.
No
Go to 3).
3) (B20) BRAKE FLUID LEVEL SWITCH CIRCUIT OPEN
Fig. 3: Measuring Resistance Of (B20) Brake Fluid Level Signal Circuit Between Brake Fluid Level
Switch Harness Connector And TIPM Harness Connector
Courtesy of CHRYSLER LLC
Turn the ignition off.
Disconnect the Brake Fluid Level Switch.
2007 Dodge Nitro R/T
2007 BRAKES ABS - Electrical Diagnostics - Nitro
Disconnect the TIPM harness connector.
Measure the resistance of the (B20) Brake Fluid Level signal circuit between the Brake Fluid Level
Switch harness connector and the TIPM harness connector.
Is the resistance below 5 ohms?
Yes
Go to 4).
No
Repair the open in the (B20) Brake Fluid Level Switch signal circuit.
Perform ABS VERIFICATION TEST.
4) (Z905) SENSOR GROUND CIRCUIT OPEN
2007 Dodge Nitro R/T
2007 BRAKES ABS - Electrical Diagnostics - Nitro
Fig. 4: Measuring Resistance Of (Z905) Brake Fluid Level Switch Ground Circuit Between Brake
Fluid Level Switch Harness Connector And Ground
Courtesy of CHRYSLER LLC
Turn the ignition off.
2007 Dodge Nitro R/T
2007 BRAKES ABS - Electrical Diagnostics - Nitro
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст