Dodge Nitro. Manual — part 569
Fig. 142: Identifying Bolt & Remover 9958-3
Courtesy of CHRYSLER LLC
2. Bolt (1) Remover 9958-3 (2) to axle tube bushing. Drive bushing out with a hammer.
AXLE BRACKET BUSHING
Fig. 143: Identifying Bushing Flange Flat Location
Courtesy of CHRYSLER LLC
1. Mark bushing flange flat location (1) on the axle bracket for installation reference.
2007 Dodge Nitro R/T
2007 DRIVELINE Differential & Driveline - Nitro
Fig. 144: Identifying Spacer 9958-1, Receiver 9958-6 & Remover 9958-5
Courtesy of CHRYSLER LLC
2. Clamp Press C-4212F into vise.
3. Place Spacer 9958-1 (1) over bushing in the bracket. Press bushing out of the bracket into Receiver 9958-
6 (1) with Remover 9958-5 (3) and Press C-4212F.
INSTALLATION
BUSHING-AXLE
PINION NOSE BUSHING
CAUTION: Bushing must be installed in the original location ± 2 degrees. Failure to
follow these instruction will result in damaging the bushing and a NVH
problem.
2007 Dodge Nitro R/T
2007 DRIVELINE Differential & Driveline - Nitro
Fig. 145: Identifying Receiver 9958-2 & Flat Spots
Courtesy of CHRYSLER LLC
1. Start bushing in axle housing with bushing reference mark aligned.
2. Center one of the Receiver 9958-2 (1) flat spots (2) under pinion for tool clearance.
Fig. 146: Installing Bushing With Installer 9958-3, Receiver 9958-2 And Press C-4212F
Courtesy of CHRYSLER LLC
3. Install bushing (1) with Installer 9958-3 (2) Receiver 9958-2 (3) and Press C-4212F.
AXLE TUBE BUSHING
2007 Dodge Nitro R/T
2007 DRIVELINE Differential & Driveline - Nitro
Fig. 147: Installing Bushing With Installer 9958-3, Receiver 9958-2 And Press C4212F
Courtesy of CHRYSLER LLC
1. Start bushing in axle tube with bushing reference mark aligned.
2. Center one of the Receiver 9958-2 (3) flat spots over the axle tube for tool clearance.
3. Install bushing (1) with Installer 9958-3 (2) Receiver 9958-2 (3) and Press C4212F.
AXLE BRACKET BUSHING
Fig. 148: Identifying Bushing, Receiver 9958-6, Spacer 9958-1 & Installer 9958-3
Courtesy of CHRYSLER LLC
1. Start bushing in axle bracket with bushing reference mark aligned.
2. Install bushing (1) with Receiver 9958-6 (2) Spacer 9958-1 (3) position in bracket, Installer 9958-3 (4)
and Press C4212F. Press bushing through the first side of the bracket then remove Spacer 9958-1 (3).
2007 Dodge Nitro R/T
2007 DRIVELINE Differential & Driveline - Nitro
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст