Dodge Nitro. Manual — part 440
Fig. 406: Removing/Installing Sun Visor
Courtesy of CHRYSLER LLC
1. If equipped, connect the illuminated vanity mirror wire harness connector.
2. Position the sun visor (2) to the headliner/roof (1) and install the screws. Tighten the screws to 2 N.m (20
in. lbs.).
LIFT GATE
BUMPER - LIFTGATE
REMOVAL
BUMPER - LIFTGATE
2007 Dodge Nitro R/T
2007 ACCESSORIES AND EQUIPMENT Body - Nitro
Fig. 407: Lift Gate Bumper
Courtesy of CHRYSLER LLC
1. Open the lift gate.
2. Remove the screws (2) and bumper (1) from the body.
INSTALLATION
BUMPER - LIFTGATE
Fig. 408: Lift Gate Bumper
Courtesy of CHRYSLER LLC
1. Install the bumper (1) and screws (2) to the body and tighten to 12 N.m (106 in. lbs.).
NOTE:
Make sure the bumper is properly oriented with printed arrows pointing
inboard.
2007 Dodge Nitro R/T
2007 ACCESSORIES AND EQUIPMENT Body - Nitro
2. Close the lift gate.
HANDLE - EXTERIOR
REMOVAL
HANDLE - EXTERIOR
Fig. 409: Liftgate Trim Panel
Courtesy of CHRYSLER LLC
1. Remove two bolts (2) from the lower trim panel (3).
2. Using a trim stick C-4755 or equivalent, release the fasteners at all of the locations around the trim panel
(3).
3. Lift the trim panel (3) from the lift gate (1).
Fig. 410: Latch Cable
Courtesy of CHRYSLER LLC
2007 Dodge Nitro R/T
2007 ACCESSORIES AND EQUIPMENT Body - Nitro
4. Disconnect the latch cable (1) from the lift gate handle (2).
Fig. 411: Exterior Lift Gate Handle
Courtesy of CHRYSLER LLC
5. Remove the two nuts (4).
6. Disconnect the electrical connector (2).
7. Using a trim stick C-4755 or equivalent, remove the exterior lift gate handle (1) from the lift gate (3).
INSTALLATION
HANDLE - EXTERIOR
Fig. 412: Exterior Lift Gate Handle
Courtesy of CHRYSLER LLC
1. Install the exterior lift gate handle (1) to the lift gate (3).
2007 Dodge Nitro R/T
2007 ACCESSORIES AND EQUIPMENT Body - Nitro
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст