Dodge Viper SRT-10 (ZB). Manual — part 311
Symptom:
CD PLAY FAILURE
When Monitored and Set Condition:
CD PLAY FAILURE
When Monitored:
Continuously with the ignition and the radio CD player turned on.
Set Condition:
The code will set if a CD that is not formatted as a music CD or is
scratched, dirty so the radio can not play the CD.
POSSIBLE CAUSES
CD PLAY FAILURE
TEST
ACTION
APPLICABILITY
1
Replace the problem CD with a good, clean, unscratched, music CD.
Turn the radio CD player on.
With the DRBIII
t, read DTC’s.
Does the DRBIII
t display CD PLAY FAILURE?
All
Yes
→ Replace the Radio.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Test Complete.
137
AUDIO
Symptom:
CD READ FAILURE
When Monitored and Set Condition:
CD READ FAILURE
When Monitored:
Continuously with the ignition and the radio CD player turned on.
Set Condition:
The code will set if a CD that is not formatted as a music CD is installed
in the radio CD player.
POSSIBLE CAUSES
CD READ FAILURE
TEST
ACTION
APPLICABILITY
1
Replace the problem CD with a good, clean, unscratched, music CD.
Turn the radio CD player on.
With the DRBIII
t, read DTC’s.
Does the DRBIII
t display CD READ FAILURE?
All
Yes
→ Replace the Radio.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Test Complete.
138
AUDIO
Symptom:
CD TEMPERATURE HIGH
When Monitored and Set Condition:
CD TEMPERATURE HIGH
When Monitored:
Continuously with the ignition and the radio CD player turned on.
Set Condition:
The code will set if the temperature inside the radio CD player is above
+85° C (+185° F).
POSSIBLE CAUSES
HIGH TEMPERATURE FAILURE
TEST
ACTION
APPLICABILITY
1
With the DRBIII
t, erase the audio DTC’s.
Start the engine and allow the engine to reach normal operating temperature.
If the vehicle has been in the hot sunlight or extreme cold move the vehicle indoors
and open the doors to allow the inside temperature to stabilize.
The radio CD player will operate between -30° C and 85° C (-22° F and +185° F).
With the DRBIII
t, read DTC’s.
Does the DRBIII
t display CD TEMPERATURE HIGH?
All
Yes
→ Replace the Radio.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Test Complete.
139
AUDIO
Symptom:
LOW VOLTAGE LEVEL
When Monitored and Set Condition:
LOW VOLTAGE LEVEL
When Monitored:
Set Condition:
The radio detects lower than normal voltage.
POSSIBLE CAUSES
CHECK CHARGING SYSTEM
CHECK VOLTAGE LEVEL AT RADIO
RADIO
TEST
ACTION
APPLICABILITY
1
Check the charging system in accordance with the service information.
Is the charging system operating properly?
All
Yes
→ Go To 2
No
→ Refer to the appropriate service information and repair as neces-
sary.
Perform BODY VERIFICATION TEST - VER 1.
2
Turn the ignition off.
Disconnect the Radio harness connector.
Start the engine.
Measure the voltage of each Fused B+ circuit and the Fused Ignition Switch Output
circuit.
Is the voltage above or approximately 14 volts for each measurement?
All
Yes
→ Go To 3
No
→ Repair the circuit for high resistance.
Perform BODY VERIFICATION TEST - VER 1.
3
Note: Reconnect all previously disconnected components.
Turn the ignition and Radio on.
With the DRBIII
t, erase the audio DTC’s.
Start the engine.
With the DRBIII
t, read the audio DTC’s.
Did this DTC reset?
All
Yes
→ Replace the Radio.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Test Complete.
140
AUDIO
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст