Lifan 620. Manual — part 21
Table 1-64 (Continued)
S/N Operation Test
Results
Actions
Yes Next
step
11
Check if the fuel pressure is lower than 250kPa.
No 15
Yes Next
step
12
Close the fuel gauge valve. Turn on the ignition switch
again and keep the fuel pump working for 3 seconds.
13
14
15
16
17
18
85
15. A/C system trouble
Table 1-65
S/N Operation Test
Results
Actions
Yes Next
step
1
Check if the refrigerant of the A/C system is enough.
Check the A/C belt, clutch, pressure switch for normal
operation.
No
Remove the trouble
Yes
Remove the trouble
2
Run the engine at an idle speed. Turn on the A/C switch.
3
4
5
1
2
No
Repair or replace
Yes 5
3
Take out the connector of each ignition coil in sequence.
Check if no decrease of the rotation speed of the engine
is produced at any moment for the cylinder.
No Next
step
Yes Next
step
4
Check if there is running sound for each fuel injector at
idle speed.
No
Check fuel injector and
relevant circuits
86
Table 1-66 (Continued)
S/N Operation Test
Results
Actions
Yes Next
step
5
Remove the ignition metal wire from the spark plug. Install
the wire to a normal spark plug. Place the bottom end of
the spark plug towards the gound, and then turn to the
engine. Check if the spark is normal.
No
Check ignition coil, giant
transistor, and their
circuits
No Next
step
6
Remove the spark plug. Check the place for dirts.
7
8
9
10
11
Check the intake air sensor signal with a diagnostic
instrument. (2.0-6.0gm/sec, at idle speed,
7.0-20.0gm/sec, at 2500rpm)
No
Check the connector of
the air intake temperature
sensor circuit for rust or
looseness.
87
II. TRITEC 1.6 engine
1. Fail to run or run slowly at start
Common trouble location:
1. Battery; 2. Start motor; 3. Harness or ignition switch; 4. Mechanical paof the engine.
Diagnosis Flow
Table 1-67
S/N Operation Test
Results
Actions
1
2
3
4
5
88
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст