Lifan 620. Manual — part 25
Table 1-78 (Continued)
S/N Operation Test
Results
Actions
Yes Next
step
5
Check the spark plug for each cylinder. Check if its
model and gap can meet with starndards.
No
Adjust or replace
Yes Wash
relevant
parts
6
7
8
9
10
11
Yes Diagnosis
help
12
Connect the electronic injection system adapter. Turn on
the ignition switch. Check the power supply of the pin
12#, 13#, 44#, 45#, 63#. Check the grounding of the pin
3#, 51#, 53#, 61#, 80#. Are they OK?
No
Check and repair
relevant line
101
Section V Security Items for System Maintenance
1. Security items for the diagnosis and maintenance of the fuel injection electronic control system
(1) Remove and install requirements for the controller
Remove the controller before welding and paint baking;
①
Turn the ignition switch to OFF when remove the controller to avoid damage;
②
When the engine is running or
③
the electrical system is under operation, do not disconnect with
the battery;
Do not st
④
art the engine with high electricity from charger;
⑤
①
②
①
③
④
⑤
⑥
⑧
apply a little lubricant to the O-ring.
After the system being opened, try not to use compressed air and make the vehicle move.
2. Security measures
To avoid personal injury and damage the fuel injection and ignition device:
Do not connect or disconnect the ignition harness if the engine is under operation or at a rotation speed
for start-up; disconnect the harness connector from the hall sensor (distributor) if the engine is driven by
the starting motor yet not actually started (like compressed pressure check, etc).
102
Chapter II Chassis System
Section I Suspension and Axle
I. Overview
1. Front axle and front suspension, Fig. 2-1.
8. Cotter pin 9. Hexagon flange slotted nut (100 N·m)
10. Left front lower arm assembly 11. Sub-frame rubber plug
12. Sub-frame assembly 13. Hexagon bolt with flat washer (210 N·m)
14. Hexagon flange nut (75 N·m) 15. Front stabilizer rod rubber mount
16. Front stabilizer rod hoop 17. Hexagon bolt with taper washer (23 N·m)
18. Front stabilizer rod assembly 19. Hexagon flange nut
20. Right front lower arm assembly 21. Right front shock damper assembly
22. Hexagon flange nut (75 N·m)
103
Thus
please do not adjust the inclination and caster angle of the kingpin.
(5) The non-payload is lighter, which helps to decrease the impact load on the suspension and
improve the driving smoothness of the vehicle.
(6) The left and right wheels are independently hinged, which assists the wheels to contact the
104
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст