Lifan 620. Manual — part 24
9. With normal start, unstable idle speed or flameout under partial load (with A/C on, etc)
Common trouble location:
1. A/C system; 2. Idle speed regulator; 3. Fuel injector
Diagnosis Flow
Table 1-75
S/N Operation Test
Results
Actions
Yes Adjust
1
Check if the accelerator cable is locked or over
2
3
4
5
6
97
10. With normal start, idle speed too fast
Common trouble location: 1. Throttle body and idle speed by-pass air way; 2. Vacuum pipe; 3. Idle
speed regulator; 4. Coolant temperature sensor; 5. Ignition timing
Diagnosis Flow
Table 1-76
S/N Operation Test
Results
Actions
1
2
3
4
5
6
98
11. Unfavorable rotation speed or flameout during acceleration
Common trouble location:
1. Fuel with water; 2. Intake air pressure sensor and throttle position sensor;
3. Spark plug; 4. Throttle body and idle speed by-pass air way;
5. Intake air way; 6. Idle speed regulator;
7. Fuel injector; 8. Ignition timing; 9. Exhaust pipe.
Diagnosis Flow
Table 1-77
1
2
3
4
5
6
No Next
step
7
Check the fuel for normal operation.
Yes Next
step
8
Check if the ignition sequence and timing of the engine
can meet with the standards.
No
Check and repair
ignition timing
99
Table 1-77 (Continued)
S/N Operation Test
Results
Actions
Yes Next
step
9
Check the exhaust pipe for smoothness.
No
Repair or replace
exhaust pipe
Yes Diagnosis
help
10
Connect the electronic injection system adapter. Turn on
the ignition switch. Check the power supply of the pin
12#, 13#, 44#, 45#, 63#. Check the grounding of the pin
Check and repair
1
2
3
Yes Next
step
4
Draw out the wire of one of the cylinders, and connect
with the spark plug. Keep the electrode of the spark plug
about 5mm from the engine body. Start the engine, and
and check if the high voltage fire is normal.
No
Check and repair
ignition system
100
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст