Lifan 620. Manual — part 12
7. DTC: P0130, Upper Oxygen Sensor Signal Circuit Trouble (see Table 1-20)
(Note: If the trouble of P0135 occurs simultaneously, please remove the trouble of P0135 at first,
and then go to the following steps.)
Table 1-20
S/N Operation Test
Results
Actions
1
Connect the diagnostic instrument and adapter, and turn the
ignition switch to ON.
Next
step
Yes Diagnosis
help
2
Start the engine, and keep idle speed until the coolant reaches
3
4
1
2
Yes
Repair or replace
harness
3
Check for short to power supply between pin 36#, 18# of the
ECU and pin A# (to the grey connection line of the oxygen
sensor), B# (to the black connection line of the oxygen sensor)
of the sensor with a multimeter.
No Diagnosis
help
49
9. DTC: P0134, Upper Oxygen Sensor Signal Circuit Trouble (see Table 1-22)
(Note: If the trouble of P0135 occurs simultaneously, please remove the trouble of P0135 at first,
and then go to the following steps.)
Table 1-22
S/N Operation Test
Results
Actions
1
Connect the diagnostic instrument and adapter, and turn the
ignition switch to ON.
Next
step
Yes Diagnosis
help
2
Start the engine, and keep idle speed until the coolant reaches
3
1
2
3
4
Yes
Repair or replace
harness
5
Check for open circuit, short to power supply or ground
between the pin 1# of the ECU, pin 87# of the main relay and
the pin C# (to the white connection line of the oxygen sensor)
and the pin D# (to the white connection line of the oxygen
sensor) of the sensor with a multimeter.
No Diagnosis
help
50
11. DTC: P0171, Air Fuel Ratio Closed Loop Control Self-adaptation Upper Limit Break (see
Table (1-24)
(Note: If the DTC related to intake air pressure sensor, canister control valve, oxygen sensor is
produced, please remove these troubles at first, and then go to the following steps.)
Table 1-24
S/N Operation Test
Results
Actions
1
2
3
4
5
51
12. DTC: P0172, Air Fuel Ratio Closed Loop Control Self-adaptation Bottom Limit Break (see
Table 1-25)
(Note: If the DTC related to intake air pressure sensor, canister control valve, oxygen sensor is
produced, please remove these troubles at first, and then go to the following steps.)
Table 1-25
S/N Operation
Test
Results
Actions
1
Connect the diagnostic instrument and adapter, and turn the
2
3
4
5
52
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст