Infiniti Q45 (FY33). Manual — part 349
TEL165M
GI
MA
EM
LC
EC
FE
AT
PD
FA
RA
BR
ST
RS
BT
HA
IDX
INTERIOR ILLUMINATION CONTROL — IVMS
Wiring Diagram — ROOM/L — (Cont’d)
EL-387
TEL166M
INTERIOR ILLUMINATION CONTROL — IVMS
Wiring Diagram — ROOM/L — (Cont’d)
EL-388
SEF046TA
CONSULT-II
CONSULT-II INSPECTION PROCEDURE
1.
Turn ignition switch “OFF”.
2.
Connect “CONSULT-II” to the data link connector.
PBR455D
3.
Turn ignition switch “ON”.
4.
Touch “START”.
SEL471W
5.
Touch “IVMS”.
SEL485W
6.
Touch “INTERIOR ILLUMINATION”.
SEL480W
I
DATA MONITOR and ACTIVE TEST are available for the inte-
rior illumination.
GI
MA
EM
LC
EC
FE
AT
PD
FA
RA
BR
ST
RS
BT
HA
IDX
INTERIOR ILLUMINATION CONTROL — IVMS
EL-389
Trouble Diagnoses
WORK FLOW
CHECK IN
LISTEN TO CUSTOMER COMPLAINT
IVMS COMMUNICATION DIAGNOSIS (EL-291 or EL-297)
Do self-diagnostic results exist?
Yes
No
SYMPTOM
BASIS
E
Repair/Replace according to
the self-diagnostic results.
(EL-293)
Perform diagnostic procedure
according to the symptom chart
on the next page.
F
NG
IVMS COMMUNICATION
DIAGNOSIS (EL-291 or
EL-297)
OK
H
REPAIR/REPLACE
FINAL CHECK
Confirm that the malfunction is completely fixed by operating the
system.
OK
NG
CHECK OUT
NOTICE:
I
When LCU connectors are disconnected for more than 1 minute such as during trouble diagnoses,
the “disconnected” data will be memorized by the BCM. (While BCM memorizes the “disconnected”
data, IVMS communication diagnosis of CONSULT-II will display “PAST NO RESPONSE”.)
Therefore, after reconnecting the LCU connectors, erase the memory.
I
To erase the memory, perform the procedure below.
Erase the memory with CONSULT-II (Refer to EL-291.) or turn the ignition switch to “OFF” position
and remove 7.5A fuse [No.
14
located in the fuse block (J/B)].
INTERIOR ILLUMINATION CONTROL — IVMS
H
H
H
H
H
H
H
H
EL-390
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст