Infiniti M45 (Y34). Manual — part 281
VDC/TCS/ABS ACTUATOR
BRC-67
[VDC/TCS/ABS]
C
D
E
G
H
I
J
K
L
M
A
B
BRC
VDC/TCS/ABS ACTUATOR
PFP:47660
Removal and Installation
AFS000MD
Pay attention to the following when removing actuator.
CAUTION:
●
Before servicing, disconnect battery cables.
●
To remove brake tube, use a flare nut wrench to prevent flare nuts and brake tube from being dam-
aged. To install, use a flare nut wrench (commercial service tool).
●
Do not remove and install actuator by holding harness.
●
After work is completed, bleed air from brake piping. Refer to
.
●
Be sure to securely connect the ground cable.
SFIA0992E
BRC-68
[VDC/TCS/ABS]
G SENSOR
G SENSOR
PFP:47930
Removal and Installation
AFS000ME
REMOVAL
1.
Remove center console. Refer to
2.
Disconnect harness connector.
3.
Remove installation bolts. Remove yaw rate/side G-sensor.
CAUTION:
Do not drop or strike the yaw rate/side G-sensor, because it has
little endurance to impact.
INSTALLATION
To install, follow procedure for removal in reverse order.
CAUTION:
Do not drop or strike the yaw rate/side G-sensor, because it has little endurance to impact.
SFIA0818E
STEERING ANGLE SENSOR
BRC-69
[VDC/TCS/ABS]
C
D
E
G
H
I
J
K
L
M
A
B
BRC
STEERING ANGLE SENSOR
PFP:25554
Removal and Installation
AFS00265
REMOVAL
1.
Remove spiral cable assembly. Refer to
.
2.
Remove steering angle sensor from spiral cable assembly.
INSTALLATION
Install in the reverse order of removal.
NOTE:
After work, make sure to adjust neutral position of steering angle sensor. Refer to
Steering Angle Sensor Neutral Position"
SFIA1404E
BRC-70
[VDC/TCS/ABS]
STEERING ANGLE SENSOR
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст