Infiniti M45 (Y34). Manual — part 280
WHEEL SENSORS
BRC-63
[VDC/TCS/ABS]
C
D
E
G
H
I
J
K
L
M
A
B
BRC
WHEEL SENSORS
PFP:47910
Removal and Installation
AFS000MA
REMOVAL
Pay attention to the following when removing sensor.
CAUTION:
●
As much as possible, avoid rotating sensor when removing it. Pull sensors out without pulling on
sensor harness.
●
Take care to avoid damaging sensor edges or rotor teeth. Remove wheel sensor first before
removing front or rear wheel hub. This is to avoid damage to sensor wiring and loss of sensor
function.
INSTALLATION
Pay attention to the following when installing sensor. Tighten installation bolts and nuts to specified torques.
SFIA0815E
BRC-64
[VDC/TCS/ABS]
WHEEL SENSORS
●
When installing, make sure that there is no foreign material such as iron chips on pick-up and mounting
hole of the sensor. Make sure that no foreign material has been caught in the sensor rotor motor. Remove
any foreign material and clean the mount.
●
When installing front sensor, be sure to press rubber grommets in until they lock at the three locations
shown in diagram (2 at shock absorbers and 1 at body panel). When installed, harness must not be
twisted. Green line on harness (shaded part) must be visible from front.
VDC/TCS/ABS CONTROL UNIT
BRC-65
[VDC/TCS/ABS]
C
D
E
G
H
I
J
K
L
M
A
B
BRC
VDC/TCS/ABS CONTROL UNIT
PFP:47660
Removal and Installation
AFS000MB
REMOVAL
1.
Remove instrument lower panel, glove box and instrument
assist panel. Refer to
IP-10, "INSTRUMENT PANEL ASSEM-
.
2.
Remove VDC/TCS/ABS control unit.
INSTALLATION
Install in the reverse order of removal.
SFIA0816E
BRC-66
[VDC/TCS/ABS]
SENSOR ROTOR
SENSOR ROTOR
PFP:47970
Removal and Installation
AFS000MC
REMOVAL
Front
Refer to
FAX-4, "FRONT WHEEL HUB AND KNUCKLE"
in “FAX” section.
Rear
●
Follow procedure below to remove rear sensor rotor.
–
Remove side flange from rear final drive. Refer to
–
Using a bearing replacer (suitable) and puller (suitable), remove sensor rotor from the companion flange.
INSTALLATION
Front
Refer to
FAX-4, "FRONT WHEEL HUB AND KNUCKLE"
in “FAX” section.
Rear
●
Follow procedure below to install rear sensor rotor.
–
Using a drift (special service tool), press rear sensor rotor onto
the side flange.
–
Install side flange to rear final drive. Refer to
BRG1210D
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст