Infiniti M45 (Y34). Manual — part 459
DTC P1220 FUEL PUMP CONTROL MODULE (FPCM)
EC-525
C
D
E
F
G
H
I
J
K
L
M
A
EC
8.
DETECT MALFUNCTIONING PART
Check the following.
●
Harness connectors F105, M135
●
Harness connectors M141, B211
●
Harness for open or short between ECM and FPCM
>> Repair open circuit or short to ground or short to power in harness or connectors.
9.
CHECK FPCM OUTPUT SIGNAL CIRCUIT FOR OPEN AND SHORT
1.
Check harness continuity between ECM terminal 25 and FPCM terminal 1.
Refer to Wiring Diagram.
2.
Also check harness for short to ground and short to power.
OK or NG
OK
>> GO TO 11.
NG
>> GO TO 10.
10.
DETECT MALFUNCTIONING PART
Check the following.
●
Harness connectors F105, M135
●
Harness connectors M141, B211
●
Harness for open or short between ECM and FPCM
>> Repair open circuit or short to ground or short to power in harness or connectors.
11.
CHECK FPCM
Refer to
EC-525, "Component Inspection"
OK or NG
OK
>> GO TO 12.
NG
>> Replace FPCM.
12.
CHECK INTERMITTENT INCIDENT
Refer to
EC-132, "TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT"
>> INSPECTION END
Component Inspection
ABS002PY
FUEL PUMP CONTROL MODULE
1.
Start engine and warm it up to normal operating temperature.
Continuity should exist.
PBIB1129E
EC-526
DTC P1220 FUEL PUMP CONTROL MODULE (FPCM)
2.
Turn ignition switch OFF and wait at least 10 seconds.
3.
Check voltage between FPCM terminal 4 and ground under the
following conditions.
4.
If NG, replace fuel pump control module.
Condition
Voltage
When engine cranking
Approx. 0V
After starting engine
Approx. 5V
PBIB0101E
DTC P1225 TP SENSOR
EC-527
C
D
E
F
G
H
I
J
K
L
M
A
EC
DTC P1225 TP SENSOR
PFP:16119
Component Description
ABS002PZ
Electric throttle control actuator consists of throttle control motor,
acceleration pedal position sensor, throttle position sensor, etc. The
throttle position sensor responds to the throttle valve movement.
The throttle position sensor has the two sensors. These sensors are
a kind of potentiometers which transform the throttle valve position
into output voltage, and emit the voltage signal to the ECM. In addi-
tion, these sensors detect the opening and closing speed of the
throttle valve and feed the voltage signals to the ECM. The ECM
judges the current opening angle of the throttle valve from these sig-
nals and the ECM controls the throttle control motor to make the
throttle valve opening angle properly in response to driving condi-
tion.
On Board Diagnosis Logic
ABS002Q0
The MIL will not light up for this diagnosis.
DTC Confirmation Procedure
ABS002Q1
NOTE:
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at
least 10 seconds before conducting the next test.
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is more than 10V at idle.
WITH CONSULT-II
1.
Turn ignition switch ON.
2.
Select “DATA MONITOR” mode with CONSULT-II.
3.
Turn ignition switch OFF and wait at least 10 seconds.
4.
Turn ignition switch ON.
5.
If 1st trip DTC is detected, go to
EC-528, "Diagnostic Procedure"
.
WITH GST
Follow the procedure WITH CONSULT-II above.
PBIB0145E
DTC No.
Trouble diagnosis name
DTC detecting condition
Possible cause
P1225
1225
Closed throttle position learning
performance problem
Closed throttle position learning value is
excessively low.
●
Electric throttle control actuator
(TP sensor 1 and 2)
SEF058Y
EC-528
DTC P1225 TP SENSOR
Diagnostic Procedure
ABS002Q2
1.
CHECK ELECTRIC THROTTLE CONTROL ACTUATOR VISUALLY
1.
Turn ignition switch OFF.
2.
Remove the intake air duct.
3.
Check if foreign matter is caught between the throttle valve and
the housing.
OK or NG
OK
>> GO TO 2.
NG
>> Remove the foreign matter and clean the electric throttle
control actuator inside.
2.
REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR
1.
Replace the electric throttle control actuator.
2.
Perform
EC-44, "Accelerator Pedal Released Position Learning"
.
3.
Perform
EC-44, "Throttle Valve Closed Position Learning"
4.
Perform
EC-44, "Idle Air Volume Learning"
>> INSPECTION END
Removal and Installation
ABS002Q3
ELECTRIC THROTTLE CONTROL ACTUATOR
Refer to
PBIB0083E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст