Infiniti Q45. Manual — part 171
NAVIGATION SYSTEM
AV-113
C
D
E
F
G
H
I
J
L
M
A
B
AV
NAVIGATION
Display Longitude & Latitude
Able to confirm/adjust longitude and latitude.
Speed Calibration
During normal driving, distance error caused by tire wear and tire
pressure change is automatically adjusted for by the automatic dis-
tance correction function. Speed calibration function, on the other
hand, is for immediate adjustment, in cases such as driving with tire
chain fitted on tires.
GPS antenna
disconnected
Malfunctioning connection between GPS substrate in AV and NAVI
control unit and GPS antenna.
●
Navigation location detection performance
has deteriorated.
(Location correction using GPS is not per-
formed.)
●
GPS receiving status remains gray.
●
Perform self-diagnosis.
●
When connection between AV and NAVI control unit and GPS
antenna is judged normal by self-diagnosis, the symptom may
be intermittent, caused by impact or vibration.
Low voltage
of GPS
The power voltage supplied to the GPS circuit board has
decreased.
●
Navigation location detection performance
has deteriorated.
(Location correction using GPS is not per-
formed.)
●
GPS receiving status remains gray.
●
Perform self-diagnosis.
●
When connection between AV and NAVI control unit and GPS
antenna is judged normal by self-diagnosis, the symptom may
be intermittent, caused by impact or vibration.
DVD-ROM
malfunction
DVD-ROM
read error
DVD-ROM
response
Error
Malfunctioning AV and NAVI control unit.
—
Dedicated DVD-ROM is in the system, but the data cannot be
read.
●
The map of a particular location cannot be dis-
played.
●
Specific guidance information cannot be dis-
played.
●
Map display is slow.
●
Guidance information display is slow.
●
System has been affected by vibration.
●
Is DVD-ROM damaged, warped, or dirty?
–
If damaged or warped, the DVD-ROM is malfunctioning.
–
If dirty, wipe the DVD-ROM clean with a soft cloth.
●
Perform self-diagnosis.
●
When AV and NAVI control unit is judged normal by self-diagno-
sis, the symptom is judged intermittent, caused by vibration.
Error item
Possible causes
Example of symptom
Action/symptom
SKIA4575E
SKIA0365E
AV-114
NAVIGATION SYSTEM
Angle Adjustment
The turning angle output detected by the gyroscope can be adjusted.
Initialize Location
This mode is for initializing the current location.
SKIA0364E
NAVIGATION SYSTEM
AV-115
C
D
E
F
G
H
I
J
L
M
A
B
AV
CONSULT-II Function (MULTI AV)
NKS001J0
CONSULT-II can display each diagnostic item using the diagnostic test modes shown following.
CONSULT-II BASIC OPERATION PROCEDURE
Refer to
GI-36, "CONSULT-II Start Procedure"
.
VERSION
Displays version of each unit connected to the AV and NAVI control unit.
System part
Diagnosis mode
Description
MULTI AV
VERSION
Displays version of each unit connected to AV and NAVI control unit.
SELF-DIAG RESULTS
●
Performs the connection diagnosis of communication circuit between AV and NAVI control
unit and each unit, and displays the current malfunctions.
●
The DVD-ROM drive diagnosis of AV and NAVI control unit can be performed.
SIGNAL MONITOR
The diagnosis of vehicle signal that is input to the AV and NAVI control unit can be per-
formed.
SKIB0654E
Version display
Remarks
“PANEL SW”
Multifunction switch
“MAP DISK”
DVD-ROM
“HEAD UNIT”
AV and NAVI control unit
“FRONT SEAT DISPLAY”
Display
“AUDIO HEAD UNIT”
Audio unit
“AIR COMP RECEIVER”
Low tire pressure warning control unit
“BOSE AMP”
BOSE speaker amp.
“VOICE UNIT”
Voice activated control module
AV-116
NAVIGATION SYSTEM
SELF-DIAG RESULTS
The self-diagnosis is started and self-diagnosis results are displayed by touching “START” after selecting
“SELF-DIAG RESULTS”.
Display Item of SELF-DIAG RESULTS
Self-diagnosis results may be displayed simultaneously according to the cause. If some error items are dis-
played simultaneously, the detection of the cause can be performed by the combination of display items.
NOTE:
When “IVCS [ABNORMAL CONNECTION]” is indicated, this is not malfunction.
Error item
Possible cause
Action to take
HEAD UNIT
[ABNORMAL]
AV and NAVI control unit malfunction is
detected
Replace AV and NAVI control unit
BOSE AMP
[ABNORMAL]
BOSE speaker amp. malfunction is
detected
Replace BOSE speaker amp.
VOICE UNIT
[ABNORMAL]
Voice activated control module malfunction
is detected
Replace voice activated control module
MAP DISC
[NO INSERT]
DVD-ROM not inserted is detected
Insert DVD-ROM
MAP DISC
[ABNORMAL]
●
Malfunction is detected on DVD-ROM
drive pickup lens in AV and NAVI control
unit
●
There is dirt and damage on the DVD-
ROM
1. Check if the inserted DVD-ROM is specified for this
navigation system, and the DVD-ROM is dirty,
scratched or warped.
2. If the results from the above checkup show no mal-
function, insert the same DVD-ROM, and then
restart self-diagnosis.
3. If self-diagnosis results still show any malfunction,
replace AV and NAVI control unit.
MAP DISC DRIVER
[ABNORMAL 1]
MAP DISC OR DRIVER
[ABNORMAL]
●
PANEL SW
[ABNORMAL CONNECTION]
●
AUDIO HEAD UNIT
[ABNORMAL CONNECTION]
●
AIR COMP RECEIVER
[ABNORMAL CONNECTION]
●
VOICE UNIT
[ABNORMAL CONNECTION]
●
BOSE AMP
[ABNORMAL CONNECTION]
●
FRONT SEAT DISPLAY
[ABNORMAL CONNECTION]
Malfunction is detected on communication
signal
Check all communication circuits composing AV sys-
tem. Repair malfunctioning parts.
●
PANEL SW
[ABNORMAL CONNECTION]
●
AUDIO HEAD UNIT
[ABNORMAL CONNECTION]
●
AIR COMP RECEIVER
[ABNORMAL CONNECTION]
●
BOSE AMP
[ABNORMAL CONNECTION]
●
FRONT SEAT DISPLAY
[ABNORMAL CONNECTION]
Malfunction is detected on communication
signal between AV and NAVI control unit
and display
1. Check communication circuit between AV and NAVI
control unit and display.
2. If the results from the above checkup show no mal-
function, replace either AV and NAVI control unit or
display, and then start self-diagnosis.
3. If self-diagnosis results still show any malfunction,
replace the other unit.
●
PANEL SW
[ABNORMAL CONNECTION]
●
AUDIO HEAD UNIT
[ABNORMAL CONNECTION]
●
AIR COMP RECEIVER
[ABNORMAL CONNECTION]
●
BOSE AMP
[ABNORMAL CONNECTION]
Malfunction is detected on communication
signal between display and multifunction
switch
1. Check communication circuit between display and
multifunction switch.
2. If the results from the above checkup show no mal-
function, replace either display or display, and then
start self-diagnosis.
3. If self-diagnosis results still show any malfunction,
replace the other unit.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст