Infiniti Q45. Manual — part 89
DISASSEMBLY
AT-269
D
E
F
G
H
I
J
K
L
M
A
B
AT
38. Remove bracket from A/T fluid temperature sensor 2.
39. Remove O-ring from A/T assembly harness connector.
40. Disconnect TCM connectors.
CAUTION:
Be careful not to damage connectors.
41. Remove A/T assembly harness connector from control valve
with TCM using a flat-bladed screwdriver.
42. Disconnect TCM connector and park/neutral position switch
connector.
CAUTION:
Be careful not to damage connectors.
SCIA5264E
SCIA5155E
SCIA5447E
SCIA5448E
SCIA5449E
AT-270
DISASSEMBLY
43. Remove tightening bolts (1) for output shaft & companion flange
complement and transmission case.
: Bolt (10)
●
Self-sealing bolts (2)
44. Tap output shaft & companion flange complement with a soft
hammer.
45. Remove output shaft & companion flange complement from
transmission case.
46. Remove intermediate shaft from transmission case by rotating
left/right.
47. Remove seal rings from intermediate shaft.
SCIA6943E
SCIA5711E
SCIA5712E
SCIA5713E
SCIA5714E
DISASSEMBLY
AT-271
D
E
F
G
H
I
J
K
L
M
A
B
AT
48. Remove needle bearing from transmission case.
49. Remove revolution sensor from transmission case.
CAUTION:
●
Do not subject it to impact by dropping or hitting it.
●
Do not disassemble.
●
Do not allow metal filings, etc. to get on the sensor's front
edge magnetic area.
●
Do not place in an area affected by magnetism.
50. Remove reverse brake snap ring (fixing plate) using 2 flat-
bladed screwdrivers.
NOTE:
Press out snap ring from the transmission case oil pan side gap
using a flat-bladed screwdriver, and remove it using a another
screwdriver.
51. Remove reverse brake retaining plate from transmission case.
●
Check facing for burns, cracks or damage. If necessary,
replace the plate.
52. Remove N-spring from transmission case.
53. Remove reverse brake drive plates, driven plates and dish
plates from transmission case.
●
Check facing for burns, cracks or damage. If necessary,
replace the plate.
SCIA5031E
SCIA2320E
SCIA5032E
SCIA5214E
SCIA2322E
AT-272
DISASSEMBLY
54. Remove snap ring (fixing spring retainer) using a flat-bladed
screwdriver.
55. Remove spring retainer and return spring from transmission
case.
56. Remove seal rings from drum support.
57. Remove needle bearing from drum support edge surface.
SCIA2323E
SCIA2324E
SCIA3333E
SCIA2796E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст