Infiniti G37 Coupe. Manual — part 1356
TRANSMISSION ASSEMBLY
TM-277
< DISASSEMBLY AND ASSEMBLY >
[5AT: RE5R05A]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
20. Remove bearing race from rear carrier assembly.
21. Remove needle bearing from rear carrier assembly.
22. Remove mid sun gear assembly, rear sun gear assembly and
high and low reverse clutch hub as a unit.
CAUTION:
Be careful to remove then with bearing race and needle
bearing.
23. Remove high and low reverse clutch assembly from direct clutch
assembly.
CAUTION:
Make sure that needle bearing is installed to the high and
low reverse clutch assembly edge surface.
24. Remove direct clutch assembly from reverse brake.
SCIA5175E
SCIA2803E
SCIA5018E
SCIA2306E
SCIA5019E
TM-278
< DISASSEMBLY AND ASSEMBLY >
[5AT: RE5R05A]
TRANSMISSION ASSEMBLY
25. Remove needle bearing from drum support.
26. Remove snap ring (1) from A/T assembly harness connector
(A).
27. Push A/T assembly harness connector (A).
CAUTION:
Be careful not to damage connector.
28. Remove clips (1).
29. Remove oil pan (2) and oil pan gasket.
30. Remove magnets (1) from oil pan.
SCIA5198E
JPDIA0007ZZ
JPDIA0008ZZ
3
: Drain plug
: Front
: Oil pan mounting bolt
SCIA8117E
JPDIA0009ZZ
TRANSMISSION ASSEMBLY
TM-279
< DISASSEMBLY AND ASSEMBLY >
[5AT: RE5R05A]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
31. Disconnect A/T fluid temperature sensor 2 connector (A).
CAUTION:
Be careful not to damage connector.
32. Disengage terminal clips (
).
33. Disconnect revolution sensor connector (A).
CAUTION:
Be careful not to damage connector.
34. Disengage terminal clip (
).
35. Remove bolts A, B and C from control valve with TCM.
36. Remove control valve with TCM from transmission case.
CAUTION:
When removing, be careful with the manual valve notch and
manual plate height. Remove it vertically.
37. Remove A/T fluid temperature sensor 2 (1) with bracket (2) from
control valve with TCM.
SCIA8124E
JPDIA0011ZZ
: Front
Bolt symbol
Length mm (in)
Number of bolts
A
42 (1.65)
5
B
55 (2.17)
6
C
40 (1.57)
1
SCIA8077E
SCIA5260E
: Bolt
JPDIA0013ZZ
TM-280
< DISASSEMBLY AND ASSEMBLY >
[5AT: RE5R05A]
TRANSMISSION ASSEMBLY
38. Remove bracket (1) from A/T fluid temperature sensor 2 (2).
39. Remove O-ring (1) from A/T assembly harness connector (A).
40. Disconnect TCM connectors (A) and (B).
CAUTION:
Be careful not to damage connectors.
41. Remove A/T assembly harness connector (A) from control valve
with TCM using a flat-bladed screwdriver (B).
42. Disconnect TCM connector (A) and park/neutral position switch
connector (B).
CAUTION:
Be careful not to damage connectors.
JPDIA0014ZZ
JPDIA0015ZZ
JPDIA0016ZZ
JPDIA0017ZZ
JPDIA0018ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст