Infiniti G37 Coupe. Manual — part 1357
TRANSMISSION ASSEMBLY
TM-281
< DISASSEMBLY AND ASSEMBLY >
[5AT: RE5R05A]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
43. Remove tightening bolts for rear extension assembly and trans-
mission case.
44. Tap rear extension assembly with a soft hammer.
45. Remove rear extension assembly from transmission case. (With
needle bearing).
46. Remove bearing race from output shaft.
47. Remove output shaft from transmission case by rotating left/
right.
1
: Self-sealing bolt
A
: Bolt
JPDIA0026ZZ
SCIA5028E
SCIA5029E
SCIA5245E
SCIA5030E
TM-282
< DISASSEMBLY AND ASSEMBLY >
[5AT: RE5R05A]
TRANSMISSION ASSEMBLY
48. Remove parking gear (1) from output shaft (2).
49. Remove seal rings (1) from output shaft.
50. Remove needle bearing from transmission case.
51. Remove revolution sensor from transmission case.
CAUTION:
• Do not subject it to impact by dropping or hitting it.
• Do not disassemble.
• Do not allow metal filings, etc. to get on the sensor's front
edge magnetic area.
• Do not place in an area affected by magnetism.
52. Remove reverse brake snap ring (fixing plate) using 2 flat-
bladed screwdrivers.
NOTE:
Press out snap ring from the transmission case oil pan side gap
using a flat-bladed screwdriver, and remove it using a another
screwdriver.
53. Remove reverse brake retaining plate from transmission case.
• Check facing for burns, cracks or damage. If necessary,
replace the plate.
JPDIA0029ZZ
JPDIA0030ZZ
SCIA5031E
SCIA2320E
SCIA5032E
TRANSMISSION ASSEMBLY
TM-283
< DISASSEMBLY AND ASSEMBLY >
[5AT: RE5R05A]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
54. Remove N-spring from transmission case.
55. Remove reverse brake drive plates, driven plates, dish plates
and retaining plate transmission case.
• Check facing for burns, cracks or damage. If necessary,
replace the plate.
56. Remove snap ring (fixing spring retainer) using a flat-bladed
screwdriver.
57. Remove spring retainer and return spring from transmission
case.
58. Remove seal rings from drum support.
SCIA5214E
SCIA2322E
SCIA2323E
SCIA2324E
SCIA3333E
TM-284
< DISASSEMBLY AND ASSEMBLY >
[5AT: RE5R05A]
TRANSMISSION ASSEMBLY
59. Remove needle bearing from drum support edge surface.
60. Remove reverse brake piston from transmission case with com-
pressed air. Refer to
CAUTION:
Care should be taken not to abruptly blow air. It makes pis-
tons incline, as the result, it becomes hard to disassemble
the pistons.
61. Remove D-rings from reverse brake piston.
62. Use a pin punch [4 mm (0.16 in) dia. commercial service tool] to
knock out retaining pin.
SCIA2796E
SCIA5047E
SCIA6330E
SCIA2328E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст